Acro Building Systems 11710 Installation guide

Acro Building Systems

Adjustable Ladder Stand-Off User Guide

Model #11710 –Adjustable Ladder Stand-Off

Refer Question to:

info@acrobuildingsystems.com

800-267-3807

www.acrobuildingsystems.com

Warning: Failure to follow instructions for the use of this product can

result in serious personal injury.

11710 Ladder Stand-Off Instructions:

General: 1) Always follow ladder regulations and use fall protection in

accordance with local, state and federal OSHA regulations.

Mounting the 11710: 1) Hook ladder stand-off over ladder rung at a

maximum height of 3 rungs from the top of ladder. 2) Loop safety

chain around second rung above ladder stand-off. 3) Tighten securely

and clip in place. 4) Adjust spacing away from surface with 2 thumb

screws (adjusts from 22” to 29”).

Instructions for Use of 11710: 1) Raise ladder and position stand off

on solid surface or so that it sits centered on a corner. 2) Weight of

person on ladder will cause stand-off to lock on rung and gunnels. 3)

Do not stand above ladder stand-off because possible ladder kick-out

may occur!

Care and Maintenance of 11710: 1) Inspect all equipment before and

after each use to be sure that there is no damage or deformation to any

of the equipment. 2) Inspect to be sure there is no deterioration as a

result of rusting. Discard if necessary. 3) Always handle the equipment

with care to ensure safe and lasting use. 4) Do not throw or drop any

equipment from height. 5) Do not use if exposed to extreme heat or

cold. Discard at once. 6) Do not use if wet or frozen.

Made in the USA

Acro Building Systems Inc.

Acro Metal Stamping Inc.

Milwaukee, WI

ISO 9001:2008

Since 1942

MDL# PRODUCT

11710 Adjustable Ladder Stand-Off

Updated 3/30/12