2. Toro
  3. Heat Shield Kit, Z200 Baggers

Toro Heat Shield Kit, Z200 Baggers Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Toro Heat Shield Kit, Z200 Baggers Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
All Rights Reserved
Printed in the USA
2002 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Heat Shield Kit
200 Z Master
DFS Bagger
Part No. 106–7140
Form No. 3329–193
Installation Instructions
1. Insert the heat shield onto the (2) bagger mounting
screws (Fig. 1).
2. Using the heat shield as a template, locate and mark the
2 hole locations in bagger cross tube.
3. Remove the heat shield from mounting screws and drill
two 7/32 inch dia. holes in the bagger cross tube.
4. Install the heat shield onto mounting screws and secure
with the 2 jam nuts.
5. Secure the bottom of the shield to the cross tube with 2
self tapping screws.
3
1
2
4
5
6
Figure 1
1. Heat shield
2. Jam nut (2)
3. Self tapping screw (2)
4. Bagger mounting screws
5. Bagger cross tube 6. 7/32 inch hole to drill
/