Biamp Systems, 9300 SW Gemini Drive, Beaverton, Oregon 97008 U.S.A. (503) 641-7287 www.biamp.com
Ceiling Microphone
Connector
Wiring Instructions
CM1-6W and CM1-6WS
June 2013
2
CEILING MICROPHONE CONNECTOR WIRING INSTRUCTIONS
Step 1: Mount CM1-6W or CM1-6WS on ceiling tile using a 5/8″
hole.
CM1-6W
CEILING TILE
WITH 5/8″
HOLE
JBM40 PLENUM
RATED BOX
MALE &
FEMALE
PHOENIX CON
-
NECTORS
BRASS
STRAIN
RELIEF
FOR OUTER
CABLE
SLOTTED
MOUNTING
NUT
Step 3: Insert external wire through strain relief nut, then connect
the wire to the Phoenix terminal.
Recommended wire:
Belden 9451P - .124” O.D. or Belden 82761 - .116” O.D.
Step 5: Reconnect Phoenix terminals.
Step 2: Open back lid of junction box. Separate the supplied
phoenix connector (male/female).
Step 4:
Wiring:
1 = Ground
2 = Blue (+)
3 = Yellow (-)
Step 6: Tighten down the strain relief nut to hold wire rmly in
place and close junction box lid.
PHOENIX CONNECTOR WIRING INSTRUCTIONS FOR CM1-6W and CM1-6WS CEILING MICROPHONES
585.0401.90A
3
CABLE STAY ASSEMBLY
Wrap the cable around a beam, eyebolt or hanger. Next, slip the cable
through the top of cable stay barrel pulling excess cable until taut.
To release cable, depress the cable release pin on top, to release the
loop, or on bottom, to extend cable length.
CABLE
BEAM,
EYEBOLT OR
WALL
CABLE STAY
BARREL
PLENUM RATED
BOX
PLENUM RATED
CABLE
g g
g
g
g
g
g
g
CABLE
CABLE STAY
BARREL
PUSH PIN IN
TO RELEASE
CABLE RELEASE
PIN
g
g g
g g g
g g
g g
CEILING MICROPHONE CONNECTOR WIRING INSTRUCTIONS
-
1
-
2
-
3
