Hunter Fan 28573 Owner's manual

Brand: Hunter Fan

Model: 28573

Category: PC/workstation barebones

Type: Owner's manual

Hunter Fan 28573 is a stylish and functional outdoor light fixture designed for use with Hunter Outdoor Elements Ceiling Fans. This durable light fixture is suitable for wet locations and features a clear glass globe that allows for maximum light output. With its easy installation process and compatibility with a variety of Hunter ceiling fans, the Hunter Fan 28573 is an excellent choice for enhancing the look and functionality of your outdoor living space.

Hunter Outdoor Light Fixture

Installation Instructions

41770-01 05/16/2005

41770-01.indd 5/17/2005, 5:26 PM1

CAUTIONS

• Read entire installation instructions carefully before beginning instal-

lation and save these instructions.

• To reduce the risk of electrical shock, install this light xture only on

Hunter

fan type 5. Marked suitable for use in wet locations when

installed in a GFCI protected branch circuit. Note: e fan type can

be found on the ceiling fan package or on the name plate label located

on top of the motor housing of the ceiling fan.

WARNINGS

• To avoid possible electrical shock, before installing light xtures dis-

connect power by turning o the circuit breakers both to the outlet

box and to its associated wall switch location. If you cannot lock the

circuit breakers in the o position, securely fasten a prominent warn-

ing device, such as a tag, to the service panel.

• Connect house wiring to the fan before attaching the light xture to

the fan.

• All wiring must be in accordance with national and local electrical

codes. If you are unfamiliar with wiring, you should use a qualied

electrician. Professional installation is recommended.

Troubleshooting

Light does not come on.

1. Pull light pull chain one or two times to see if light comes on.

2. Make sure bulbs are installed properly and lament is not blown.

3. Make sure breakers or fuses are on.

4. Verify that the light power lead is connected at the ceiling. Refer to your

ceiling fan manual for locating assembly and wiring.

Glass rattles.

1. Make sure the glass globe is secure.

For other problems or ques-

tions, contact the Hunter Fan

Company Technical Support

1-888-830-1326 or

[email protected].

http://www.hunterfan.com

is light xture is for use

only on Hunter Outdoor

Elements

Ceiling Fans,

models 28532, 28533, 28534,

28535, and 28536.

41770-01.indd 5/17/2005, 5:26 PM2

asm0001.eps

95420-3.eps

95420-4.eps

Step 2

Steps 3-4Steps 6-7

1. Disconnect power to the ceiling fan by turning o the circuit breakers

both to the outlet box and to its associated wall switch location.

2. Align the three holes in the gasket with the three holes in the switch hous-

ing mounting plate. Partially install two screws.

3. Place the keyhole slots in the upper rain shield over the two partially

installed screws and turn the upper rain shield counter clockwise.

4. Place the keyhole slots in the upper switch housing over the two partially

installed screws and turn the upper switch housing counter clockwise.

5. Install a screw into the third hole. Securely tighten all three screws.

6. Feed the two wires from the tter through the center hole in the lower

switch housing.

7. Attach the tter to the lower switch housing with the two screws. Secure-

ly tighten the two screws. WARNING: Improper installation could cause

the light xture to fall.

8. Remove the wire nut from the black/white wire in the lower switch hous-

ing. Use this wire nut to connect the black/white wire from the lower

switch housing to the black wire from the light xture. Remove the wire

nut from the white wire in the lower switch housing. Use this wire nut to

connect the white wire from the lower switch housing to the white wire

from the light xture.

95420-5.eps

Step 5

Gasket

Upper

Rain

Shield

Upper Switch

Housing

Lower Switch

Housing

Fitter

41770-01.indd 5/17/2005, 5:26 PM3

9. Connect the 9-pin plug connectors. Attach the lower switch housing to

the upper switch housing with the three thumb screws.

10. Attach the lower rain shield to the upper rain shield with four screws.

Securely tighten all four screws.

11. Attach the wire cage to the lower rain shield with four screws. Securely

tighen all four screws.

12. Install a 75 W Max A-19 bulb.

13. Raise the glass globe and align the indents in the glass globe with the tabs

on the tter. Twist the glass globe clockwise to secure.

14. Restore power to the ceiling fan.

95420.eps

Step 9

95420b.eps

Steps 10

95420_inst.eps

Steps 12-13

95420_inst2.eps

Step 11

Lower Rain

Shield

Wire Cage

Glass

Globe

41770-01.indd 5/17/2005, 5:26 PM4

41770-01.indd 5/17/2005, 5:26 PM5

Hunter Fan Company

2500 Frisco Avenue

Memphis, Tennessee 38114

Printed in China & Taiwan

is Light Fixture weighs 7.0 lbs.

41770-01.indd 5/17/2005, 5:26 PM6

Hunter Fan 28573 Owner's manual

Brand: Hunter Fan

Model: 28573

Category: PC/workstation barebones

Type: Owner's manual

Download PDF

report

Hunter Fan 28573 Owner's manual

Hunter Fan 28573 Owner's manual

Related papers

Other documents