Instruction Manual 2
Installaion
Windows 2000/XP/Vista
To install CB1PECP on a computer running Windows 2000/XP/Vista:
1. Insert the card into an available CardBus slot. Since this card is hot-pluggable, this can be
performed while the computer is on or o. Once the card has been inserted, ensure the
computer is powered, to proceed with installation.
2. Windows will detect that the card has been inserted, and prompt for driver installation by
launching the Add New Hardware Wizard. On the rst window that appears, click Next.
3. In the window that follows, select Search for the best driver for my devices (Recommended)
and click on Next.
4. When you are prompted to Specify the location of the driver, insert the Driver CD in the
CDROM drive, and enter d:\ (where d:\ designates the location of the CDROM drive) in the
text box provided. Click Next to continue.
5. Click on Next, then Finish. When prompted, restart the computer for installation to take
eect.
Windows 98SE/ME
To install CB1PECP on a computer running Windows98SE/ME:
1. Insert the card into an available CardBus slot. Since this card is hot-pluggable, this can be
performed while the computer is on or o. Once the card has been inserted, ensure the
computer is powered, to proceed with installation.
2. Windows will detect that the card has been inserted, and prompt for driver installation by
launching the Add New Hardware Wizard. On the rst window that appears, click Next.
3. In the Window that follows, select the Specify the location... and enter d:\ in the text box
provided. Click on Next to continue.
4. Click Next and then Finish respectively, on the screens that follow. When prompted, please
reboot the computer for installation to take eect.
5. Upon rebooting, the newly installed port will be ready for use.