Effect Order Switcher
Erm...
switch the order of some effects!
Contents of this document are ©2015 Pedal Parts Ltd.
No reproduction permitted without the express written
permission of Pedal Parts Ltd. All rights reserved.
Example
Looking at the above bypass wiring diagram, the BOARD INPUT wire is the one that
would go to IN on the Order Switcher. BOARD OUT would go to OUT.
L
E
D
BOARD
OUT
BOARD
GND
BOARD
GND
BOARD
INPUT
+
IN
OUT
L
E
D
BOARD
GND
BOARD
LED+
Schematic
IN Signal IN
OUT Signal OUT
SA Send A
RA Return A
SB Send B
RB Return B
Implementation
SIGNAL
IN
SIGNAL
OUT
The example below will switch the order of the K.Buffer and the Vox Treble Boost.
Signal IN is the wire that would normally go to the IN pad if you were wiring a
single circuit, i.e. the one that would be coming from the footswitch. Same goes
for OUT.
The toggle or footswitch used for the order switcher should have the tags
orientated horizontally as shown below for the UP-DOWN version, or rotated 90°
fo the SIDE-TO-SIDE version.
PedalParts.co.uk
/
