Danfoss 080Z4009 User guide

Brand: Danfoss

Model: 080Z4009

Type: User guide

This manual is also suitable for

Danfoss 080Z4009 is a compact and versatile frequency converter that provides precise control of AC motors. With its advanced features, it is suitable for a wide range of applications, including variable speed control, energy savings, and process optimization. It offers high efficiency, reliability, and ease of use, making it an ideal choice for various industrial and commercial applications.

Setup for HGM Leak Detector with

Alarm and Strobe

AK-SM 800

Service Guide

ADAP-KOOL® Refrigeration Control System

Service Guide | AK-SM 800: Setup for HGM Leak Detector with Alarm and Strobe

2 | AX279127907281en-000101

1. From the Conﬁguration tab, select the Control subtab.

2. From the Control tab, set the number of leak detectors as the

desired number between 1 and 50.

3. Navigate to the Leak tab.

4. Set the Leak Type to HGM as desired

Service Guide | AK-SM 800: Setup for HGM Leak Detector with Alarm and Strobe

AX279127907281en-000101 | 3

5. Navigate to the Setup Tab

6. From the dropdown box, select the Leak Detector you wish to

setup. Choose the Refrigerant, Full scale value, and enable each

zone sensor that will be used.

7. Navigate to the addresses tab.

8. Go to the Sensors tab and address as desired.

4 | AX279127907281en-000101

9. Navigate back to the Conﬁguration -> Control -> Leak -> Alarms

tab to enable alarms for each zone sensor if desired.

10. Navigate to the Conﬁguration -> Control -> Refrigeration ->

Circuits -> Setup tab. Choose the leak detector you wish to

associate from the “Monitor leak detector” box. Choose the

desired zone. Enable “Generate horn relay” and “Generate

strobe relay” to “Yes” as desired. PPM triggers are conﬁgured

here as well.

11. Navigate to the Conﬁguration -> Control -> Refrigeration ->

Addresses tab and go to the relay subtab to address the horn

and strobe as desired.

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products

already on order provided that such alternations can be made without subsequential changes being necessary in specifications already agreed.