ESAB 400 Amp Automated Units Troubleshooting instruction

Type
Troubleshooting instruction
TECHNICAL
BULLETIN
Date: 8/23/2010
Product: 400 Amp Automated units By: Dirk Ott
Subject: New 400A Shield Cup and Ohmic Clip
Summary: Added groove
THERMAL DYNAMICS TECHNICAL SUPPORT
Phone: 1-800-752-7622
Fax: 1-603-298-7402
tdc-tech@thermadyne.com
www.thermadyne.com
Form 0012
82 Benning Street
West Lebanon, NH 03784
1-603-298-5711
Fax: 1-800-221-4401
“Exceeding Customer Expectations Through Performance Excellence"
The following bulletin is to inform you that along with the launch of the Ultra-Cut 400, we are also going to Introduce
a 400A shield cup (all the way to the right) and some minor changes to the lower amp shield cups (the two to the left).
9 Due to the larger diameter of the 400A shield cup, we will introduce a new ohmic clip with the part no. 9-9388
9 To guarantee a proper seating with the new ohmic clip, we are going to introduce a grove into the
shield cups where the ohmic clip will fit.
9 The Ultra-Cut 400 “starter kits” will be sent with the new 9-9388 ohmic clip.
9 All other Ultra-Cut systems will still use the existing 9-9414 ohmic clip, which can be installed on the lower amp
Shield cups as usual.
9 There will be no change to the AutoCut parts
Please feel free to contact us if you have any questions
Grove for New
Ohmic clip
Up to 150Amp 200–300 Amp NEW! 400Amp
  • Page 1 1

ESAB 400 Amp Automated Units Troubleshooting instruction

Type
Troubleshooting instruction

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI