SSP PV Series Maintenance Instructions

  • I've reviewed the provided maintenance instructions for the SSP PV Series valve. This document provides detailed steps for both rebuild and seal kit maintenance, including important notes on proper lubrication and installation. I'm familiar with the document's contents and can assist you with any questions about the maintenance procedures described.
  • What is recommended, a rebuild kit or a seal kit?
    What should be done if the valve is disconnected from a system for installation?
    What type of lubricant should be used?
Handle Handle Set Screw Plug
Rebuild Kit Instructions
1. Remove snap ring using snap ring pliers
or similar tool, and discard. See Figure 4.
Turn handle to the open position
2. Lift up handle to remove old plug
and discard entire subassembly
3. Clean body bore and lubricate lightly with
a silicone-based lubricant
4. Remove protective sleeve from
new plug. Insert plug straight down
into body. See Figure 3
5. Install snap ring with snap ring
pliers or similar tool. See Figure 4
6. Verify handle set screw is
tight, tighten as necessary
7. Test the valve for proper operation
It is recommended that a rebuild kit be used rather than a seal kit.
Insucient lubricaon, twisng of seals, etc, can adversely aect performance.
WARNING
If the valve is disconnected form
a system for installaon, it must be
depressurized, cycled, and purged.
PV Series
Maintenance Instrucons
Rebuild Kit Contents
Seal Kit Contents
O-Rings (3) Snap Ring
O-Rings (3)
2 Sizes
Figure 2
Large
O-Rings
Small
O-Ring
NOTE: Do not pinch O-Rings
between body and plug
NOTE: Brass plugs have green PTFE coang,
316 SS plugs have gray PTFE coang
Figure 1
Handle Set Screw
Handle
Plug
Snap Ring
O-Rings (3)
2 Sizes
Seal Kit Instructions
1. Remove snap ring using snap ring pliers
or similar tool. See Figure 4. Set aside.
Turn handle to the open position
2. Lift up handle to remove plug, remove
the O-Rings from the plug, and discard
O-Rings. See Figure 3
3. Clean body bore and lubricate lightly
with a silicone-based lubricant. Also
lubricate entire surface of new O-Rings
with a silicone-based lubricant. Install
O-Rings on plug, with the larger two
around the top and bottom of the plug,
and the smaller one on the side.
4. Insert plug straight down into body. See
Figure 3
5. Install snap ring with snap ring pliers or
similar tool. See Figure 4
6. Verify handle set screw is
tight, tighten as necessary
7. Test the valve for proper operation
NOTE: Do not pinch O-Rings
between body and plug
Figure 3 Figure 4
Li up
(Step 2)
Insert
Straight down
(Step 4)
www.mySSP.com PVMI-22A
/