Small Hollywood Mirror
Always read the instructions carefully before using.
Safety Instructions
Caution
Made in China
Do not immerse the appliance in water, Clean the appliance
surface with a dry cloth
If product becomes damaged, dispose of as electrical waste
according to local, state and federal requirements. Repairs
should not be attempted.
This appliance has a lithium battery. Do not place or store the
appliance for long periods of time in a hot or humid environment
If you do not intend to use the appliance for long time, store the
appliance after is fully charged
The light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire shall be
replaced
This appliance contains batteries that are non-replaceable
After long storage or rst use, press power switch if no light,
please charge 20mins and press power switch , the mirror
can light up
Continue power ON 1 hour, if there is no action on switch, the
appliance turn into dark model for energy saving , if press any
switch again, the appliance stop energy saving model
In order to saving energy and longer battery lifetime, please
switch o if end use
Once appliance turn icker and press the switch , no any
change, the power is low please charge mirror immediately
How to use the mirror
Special Feature
What's in the box
Product Specification
How to charge the mirror
The mirror is powered by
4000mAh li-polymer battery,
please make sure it is fully charged
Put your ngers on the power
switch on the mirror base, the
mirror will be lighted up.
Put your ngers on the light
button to switch between warm,
cool and daylight.
Touch the power switch again, the
lights will be
turned o.
Full charging the appliance with Type-C USB cable before rst use
Insert USB Type-C into the end of the appliance USB port
Connect the Type-C USB port with a 5V 2A power supply
When we start charging, the indicator is in Red. When the mirror is
charge full, the indicator will in Green
This lighted makeup mirror uses Lifetime Energy Saving LED
bulbs. Replacement bulbs are not required
Brightness adjusting switch
Selectable warm, cool and daylight
Tightening the screw, the mirror turn into freely angle
Keep your nger on the power
switch stay 1-3 seconds, you can
adjust the light brightness as per
your needs.
DC5V/2A Li-polymer 3.7V 4000mAh
Charging Voltage/Current Type of Battery
USB charging more environmentally friendly
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
ANKO 43304301 User manual
-
atomi AT1372 User manual
-
ANKO 43166039 User manual
-
Osram 46467-01 Datasheet
-
Comsol PMR04BU User manual
-
OttLite R34009 Rechargeable Desk Lamp Operating instructions
-
Conair BESQSN User manual
-
CipherLab RS51 Reference guide
-
NOMVDIC X300 User manual
-
Sony DSLR-A850Q Operating instructions
