Spectrum Industries 99042B, 99042S Assembly Instructions

  • Hello! I've reviewed the installation instructions for the ECA Seclusion unit, specifically the SECL-1-USB model. This document provides detailed steps for mounting the unit on or under a table, including screw types and spacing. It also covers data connections. I'm ready to answer any specific questions you have about installing this device.
  • What types of mounting are possible for the Seclusion unit?
    What type of screws are provided for mounting?
    What is the minimum table thickness required for mounting?
1
Innovative Power + Data Solutions
10 Mountain View Drive • Shelton, CT 06484 • P:800.521.3175 • F:203.924.6687 • www.electri-cable.com
©ECA–January2013—ProductspecicaonssubjecttochangewithoutnoceRLSEISLEUSB012113
Seclusion™ Installation Instructions
TABLE
TABLE
Under Table Mounting
SECL-1-USB Shown
Seclusion
Unit
Table Mount
Under Table
#8 Flat Head Screws
2 Provided
#8 Flat Head
Screws
#10 Screws
2 Required
#10 Screws
2 Required
Table Top Mounting
1. Determine if Seclusion is to be top or under table mounted, see
illustrations above.
2. Attach either Table Mount or Under Table Bracket to Seclusion
using 2 #8 flat head machine screws, provided. Note: On un-
der table mount forward edge of Seclusion to be a minimum of
1” back from table edge.
3. Determine location for Seclusion and attach to table, as
shown, using 2 #10 screws, provided (Note: Use caution to not
pierce top surface of table with screws, minimum table thick-
ness .75” thick).
4. Make data connections if required (use caution when snap-
ping RJs into faceplate to prevent them from falling into Seclu-
1/1