Epson TM-L90 Plus-i KDS Liner-free Compatible User manual

Type
User manual
111-38-QUM-021
Rev 2.30
Time on the KDS
About this Guide
This guide consists of one section:
Overview
How to Configure Time on KDS A procedure that can be followed to
configure the KDS system time.
Appendix Options for time configuration.
This guide is relevant for:
KDS FW: v2.30 and above
KDS Utility (Windows): v2.3.1.0 and above
Overview
The time is shown at the top of each KDS display and can be configured.
Figure 0.1 Kitchen Display Showing the date and time
Time on KDS
Quick User Manual
111-38-QUM-021
Rev 2.30
How to Configure
This procedure sets the current KDS time to that of the PC that is running the
Configuration Utility.
Step 1: Configuring Time Settings
1. Select Setup.
2. Select Site Wide Settings.
3. In Time Setting Actions, click “Set Current KDS Time.
4. Apply KDS Settings.
Figure 1.1 Configuring Time Settings
Time on KDS
Quick User Manual
111-38-QUM-021
Rev 2.30
Appendix
Time Settings
Time Zone: The system support time zone settings. Choose your time zone and click
“Set Time & Time Zone setting” in the Main Menu. This will update the master device
(If selected) to the new time zone settings and the current local time.
NTP Time Server: Specifies NTP Time Server. This setting must be applied by clicking
“Set Time & Time Zone Settings” in the Main Menu.
Time Setting Actions
Set Current KDS Time: Sets the date and time for this computer to the KDS system.
Does not change the time zone settings.
Set Time Zone & Time: Sets the date and time for this computer to the KDS system. It
will also change the specified time zone settings.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Epson TM-L90 Plus-i KDS Liner-free Compatible User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI