WAT RHAUS
Thank you for selecting this product!
IMPORTANT NOTICES: For easy installation, please read all
the instructions completely before beginning. Before installing
this product, make sure that water lines are properly ushed
and cleared to avoid blockage.
WARNING: Assembly by a professional plumber is required.
Clean all dirt and debris
from supply valves
before proceeding with
installation. If you are
replacing an existing
faucet, remove the faucet
from the sink and clean
the surface thoroughly.
Installation Guide
WHS1991-SK
Drill a Ø1-3/8" to Ø1-
1/2" hole (2) in sink (1).
Install the shank (3)
into the faucet body (4).
And screw them firmly.
Then put O-ring (5) into
base groove and insert
through the hole(2).
Adjust the faucet to the
right position and put on
the rubber gasket (7) and
the metal washer (8) and
lock nut (9), tighten using
a wrench.
1. Always turn off water and relieve pressure before working on your faucet.
1. Clean the faucet with mild soap and water, then wipe the faucet dry with soft cloths.
2. Do not use cleaners which contain acids, harsh chemicals, or abrasives.
3. Repeat steps 1-2 whenever necessary.
Connect the flexible hoses
to the water supply valves
(left to hot water and right
to cold). Make sure flexible
hoses are securely fastened
before turning on valve.
27
1
/
4
8
1
/
2
10
1
/
2
4
1
/
2
Pull the handle horizontally
to the right to turn on the
faucet and horizontally to
the left to turn off the faucet.
Move the handle counter
clockwise from cold to hot.
Aerator is dirty, worn or
misfitted.
Worn cartridge. Replace cartridge.
5 6
Open
Open
4
5 6
Open
Hot
Cold
4
4
2
3
7
8
9
10
6
5
4
3
2
1
5
6
25¡
ã
Open
HotC old
45
¡ã
4
5
¡ã
[P] 1.800.527.6900 WhitehausCollection.com [F] 1.800.694.4837
1 2 3
TROUBLESHOOTING