DHP-S – Schematics
The following schematics refer to models:
DHP-S
DHP-S – Htg, DHW & pool
Please note!
The information contained within this document is
intended for theoretical guidance only.
It is incumbent on the installer to ensure that all
installation and design criteria is compliant with the
relevant standards.
DHP-S
Buffer
To Heating circuit
From Heating circuit
KBH
pool
011-0001/S.C
DHP-S
Buffer
DHP-S – Htg, DHW & EK15e
To Heating circuit
From Heating circuit
KBH
Please note!
The information contained within this document is
intended for theoretical guidance only.
It is incumbent on the installer to ensure that all
installation and design criteria is compliant with the
relevant standards.
EK15e
011-0002/S.C
DHP-S
Buffer
DHP-S – Htg, DHW & boiler
To Heating circuit
From Heating circuit
KBH
Please note!
The information contained within this document is
intended for theoretical guidance only.
It is incumbent on the installer to ensure that all
installation and design criteria is compliant with the
relevant standards.
Boiler
011-0003/S.C
DHP-S
Buffer
DHP-S – Htg only
To Heating circuit
From Heating circuit
Please note!
The information contained within this document is
intended for theoretical guidance only.
It is incumbent on the installer to ensure that all
installation and design criteria is compliant with the
relevant standards.
011-0004/S.B
DHP-S
Buffer
DHP-S – Htg & DHW
To Heating circuit
From Heating circuit
KBH
Please note!
The information contained within this document is
intended for theoretical guidance only.
It is incumbent on the installer to ensure that all
installation and design criteria is compliant with the
relevant standards.
011-0005/S.C
Hot gas
DHP-S
Buffer
DHP-S – Htg & DHW
To Heating circuit
From Heating circuit
KBH 1000
Please note!
The information contained within this document is
intended for theoretical guidance only.
It is incumbent on the installer to ensure that all
installation and design criteria is compliant with the
relevant standards.
012-0006/S.B
KBH 250
Hot gas
DHP-S
Buffer
DHP-S – Htg & DHW
From Heating circuit
KBH 1000
Please note!
The information contained within this document is
intended for theoretical guidance only.
It is incumbent on the installer to ensure that all
installation and design criteria is compliant with the
relevant standards.
012-0007/S.B
KBH 250
EK15e
Electrical wiring
Motor Exchange valve
Auxilliary heater
Circulation pump
Isolation valve
Primary expansion & PRV
Filter
Brine expansion
CW stop tap
DHW outlets
Flow direction
Legend
Danfoss boundary
Shunt valve
/