Danfoss Electro Mechanical Room Thermostat Installation guide

Brand: Danfoss

Model: Electro Mechanical Room Thermostat

Type: Installation guide

Instructions

RMT-24, RMT-24T, RMT-24R

Fig. 4.

Fig. 5.

Fig. 6.

Fig. 7.

Fig. 10.

Fig. 9.

Fig. 8.

Fig. 2.

Fig. 1.

Fig. 3.

Location, fig. 1.

Do not site the room thermostat in a

draught, in direct sunlight or close to

appliances giving off heat (e.g. television

set).

Fixing, fig. 2. and 3.

Make sure the supply voltage to the system

is disconnected before commencing

installation or subsequentially removing

the thermostat cover.

Fix the base moulding on a flat wall or on

a flush box.

The temperature range can be limited by

moving the two springs on the back of the

setting knob, fig. 4.

Wiring, fig. 5, 6 & 7.

Switch function: SPDT, fig. 8, 24V, 50-

60Hz, 10 (4) A.

Min. contact load: 70 mA

When the cable is to be wired through the

side of the thermostat, break out the

knockout with a pair of pliers (fig. 9 & 10).

When the room thermostat is connected

to an inductive load, without noise

suppression, there might be a risk of radio

and TV interference.

RMT versions with parallel accelerator

Rp, will have a lower temperature

differential when terminal ❶ is connected

as shown in fig. 5 & 6.

RMT-24T and RMT-24R only

RMT-24T and RMT-24R will set-back the

temperature by 5K, when the built-in

resistance Rn is connected as shown in

fig. 6 & 7.

NB. RMT-24R is only to be applied together

with an ABN actuator of the NO-type

(Normally Open).

Part No: 9106 Iss.1. 11/98

Danfoss Electro Mechanical Room Thermostat Installation guide

Danfoss Electro Mechanical Room Thermostat Installation guide

Danfoss Electro Mechanical Room Thermostat Installation guide

Related papers

Other documents