Broilmaster DPA155 Heat Indicator s Installation guide

Type
Installation guide

This manual is also suitable for

B102536-0-0519Page 1
PREMIUM GRILLS
DPP155-1
HEAT INDICATOR INSTALLATION INSTRUCTIONS
HEAT INDICATOR RECALIbRATION
The heat indicator can be recalibrated if needed. Remove
the heat indicator from the grill and place the stem in a pot
of boiling water. Set the indicator by turning the screw in the
end of the stem until it reads 212 degrees. The indicator is
now set and can be reinstalled.
M8 x 1 HEX NUT
8-32 SCREW
MOUNTING PLATE
8-32 NUT
FOR GRILL LIDS WITH
THREE MOUNTING HOLES
M8 x 1 HEX NUT
SPACER
FLATWASHER
FOR GRILL LIDS WITH
ONE MOUNTING HOLE
HEAT INDICATOR MOUNTINg
The heat indicator and bezel are attached to the grill lid with
an M8x1 hex nut which is supplied with the indicator. On grill
lids with three holes, attach the mounting plate to the lid rst
as shown, remove the nut from the indicator, and then insert
the stem of the indicator through the mounting plate center
hole and then tighten the nut. On lids with one hole, insert the
spacer into the lid hole, remove the nut from the indicator, and
then insert the stem of the indicator through the spacer
and the at washer and then tighten the nut.
CARTON CONTENTS
Part No. Description Qty. Supplied
B102487
Heat Indicator With Nut
1
B102486 Flat Washer 1
B102491 Spacer 1
B101624 8-32 Screw 2
B101663 8-32 Nut 2
B102534 Mounting Plate 1
B102536-0-0519Page 2
bROILMASTER
®
A Division of Empire Comfort Systems, Inc.
918 Freeburg Ave.
Belleville, Illinois 62220
Visit our web site at www.broilmaster.com
If you have a general question about our products, please e-mail us at [email protected].
If you have a service or repair question, please contact your dealer.
  • Page 1 1
  • Page 2 2

Broilmaster DPA155 Heat Indicator s Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI