PRESYS PREAMP INSTALLATION GUIDE
fishman.com
Step 2: Sonicore Pickup
Installation
Drill a
3
/
32
” hole (2.4mm) in the
saddle slot for the pickup wire,
no less than .100” (2.5mm) from
nearest string. Refer to Sonicore
installation guide for further
details.
Widen the endpin hole to
15
/
32
”
(11.9mm) to accomodate the
endpin output jack. Refer to
Endpin Jack installation guide
for further details.
Position the preamp on the flat-
test convenient surface on the
side of the instrument that also
allows internal clearance. Cut out
cavity for preamp using supplied
template.
Step 3: Preamp Location
Step 1: Endpin Jack
Installation
Attach the preamp to the guitar
using the supplied screws and
mounting brackets.
Step 4: Attach Preamp
x2
x2
≥ .100”
[≥2.5mm]
.093”
[2.4mm]
ENDPIN JACK INSTALLATION
fishman.com
Step 3
Add outside washer and nut. Tighten
using small screwdriver and wrench
Add strap nut. Tighten securely with
rubber tipped pliers
When jack is properly installed, end of
threaded barrel should remain outside
top of strap button
Step 5
*IMPORTANT
(close up inside guitar)
/
