Place the Digital Radio on a secure, flat level surface
that is not subject to vibration.
Best reception will be obtained with the aerial raised
and extended. Find the best direction to point to.
Plug the Power Adaptor into a mains outlet socket
and switch on.
Press the POWER ON/OFF switch on the rear panel
to turn on the Digital Radio.
Pull out the battery safety tab to connect the battery
already fitted in the remote control.
Soon after the scanning finishes, the first station stored
in the radio’s memory will play.
The LCD display will display a ‘scanning’ message
similar to that shown above.
Plug the lead from the Power Adaptor into the
connector on the rear panel as shown.