Digital Alarm Clock

Instructions

Hearing Products

International Limited

www.hear4you.com

Replacement Parts

Digi-Wake Digital Clock

Vibrator

EN61000-3-3: 2008

Mains Power Adapter:

EN609050-1/A11:2009

BS 60950-1A/11:2009

Hearing Products

Hearing Products International Ltd. Reserve sole right to alter prices, design and or technical specifications or colours without

prior notice E & O.E. 06/07/2011 Copyright Hearing Products International Limited 2011 Echo DigiWake 474-1004-01

Instructions

IMPORTANT

a) When using this unit, basic safety precautions as below should always be followed to avoid the risk of

electric shock or personal injury.

b) Do not use in an environment that is damp, wet, very hot or very cold.

c) To clean the clock and its accessories, use only a soft cloth and an inorganic cleaner.

d) Install the unit securely on a stable surface and install the unit where the power cord will not be

subject to damage or cause a tripping hazard.

e) The unit may get warm when being used; ensure the unit has adequate ventilation.

f) Only use the Hearing Products approved mains adapter. Do not use any other type of mains adapter.

is switched on. The 9V drycell (not included) can be used to hold the time and alarm settings should there

be a mains power failure. The clock will operate perfectly well with just the mains power adapter and

without the 9v drycell (not included). The 9v drycell (not included) is only if you want backup.

CONTENTS

1 x Alarm Clock

1 x Vibrator unit

1 x Mains power adapter 9V DC 800mA Positive Centre

Set up Procedure

1) Remove the cover from the drycell compartment.

2) Place 9V Drycell correctly in the compartment (not included).

When the clock is first plugged in, the display will blink on and off meaning the correct time needs to be set.

If the clock is set for 12 hour mode and you wish to set the time to PM, the clock PM indicator should be lit.

When it is off, it indicates 'AM'. Unless using the 24 hour clock.

To alter between 12 and 24 hour display you will need to flick the switch which is located in the battery

compartment.

When the alarm indicator is on the alarm will sound at the set time.

Set Time

PLEASE NOTE....that the clock will be set to 24 hour mode on delivery (not 12 hour mode)

1. Press the time button and the hour button at the same time until the correct hour time is displayed.

2. Release the hour and press the Minute button (still pressing the time button) until the correct minute

To Set the Alarm

correct Alarm minute is displayed.

3. Be sure to select AM/PM correctly, unless using the 24 hour clock.

To Operate the Alarm

Slide the Alarm On/Off switch to On Position. The alarm will then sound at the set time.

Snooze

When the snooze button is depressed, the snooze button gives 8-9 minute snooze.

Hi-Low Dimmer Switch

If more intense display is preferred, slide the dimmer HI/LOW switch to the 'HI' position. If less intense

display is desired, slide the Dimmer HI/LOW switch to the 'LOW' position.

To operate Vibrate

Power Supply : Drycell 1 9V (not included)

: Mains adapter 9V DC 800mA positive centre.

Dimensions : 190mm (L) x 80mm (D) x 30mm (H)

Weight : 223 grams excluding battery