Lightolier IS:5453 User manual

Brand: Lightolier

Model: IS:5453

Category: Wall & ceiling mounts accessories

Type: User manual

Lightolier IS:5453 is a lighting fixture designed for indoor use. It can be mounted on a wall or ceiling and is suitable for use in damp locations. The fixture has a modern design with a rectangular backplate and a round diffuser. It is available in a variety of finishes, including white, black, and brushed nickel.

The Lightolier IS:5453 is easy to install and comes with all the necessary hardware. It uses two standard light bulbs, which are not included. The fixture provides ample light for a variety of applications, including kitchens, bathrooms, and hallways.

Here are some of the features of the Lightolier IS:5453:

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

his fiXtIIrO

k intendedfor installationin acmrdsnca with the NationalEbafrisalCode and IOCA

INSTRUCTION SHEET NO.

!gulations.To assure full mmpliansa with Iosal rndes and regulations, shesk with your local elestrissl

lspestorbefore installation. To prevent elestrisal shosfr,tum ofi eleatdsity at fuse box before prmeeding.

IS:5453

Retain Iheae instructions for maintenance reference.

1291

INSTRUCTIONS FOR INSTALLATION OF 5453

CAUTION

DO NOT MOUNT TOP EDGE OF FIXTiJRE CLOSER THAN 6 INCHES TO CEILING.

FOR OCTAGONALOUTLETBOXES

. Position BACKPWTE ASSEMBLY centered over OUTLET BOX with bottom edge of BACKPLATE in fine with bottom of OUTLET SOX. (Fig. 1).

Using all MOUNTING HOLESin BACKPL4TEASSEMBLY, semretowallusingwood stiews,toggleklts, oralternatefasteners (notprovided) depending

on WSIImaterial. NOTE BACKPLATE ASSEMBLY should be leveled horizontally and outlet box completely covered before final tightening to wall.

‘OR HORIZONTALLY MOUNTED RECTANGULAR GEMORSWITCHOUTLETBOXES

. Remove COVER PIATE horn BACKPLATE ASSEMBLY aa shown in Fig 3.

:,Position BACKPIATE ASSEMBLY centered over OUTLET BOX with bottom edge of BACKPMTE in line with botiom of OUTLET BOX.(Fig. 2).

. Uaingall MOUNTING HOLES inBACKPIATEASSEMBLY, aecuretowall usingwoodaixews, toggle bolta,oralternatefasteners (not provided) depending

on wall material.

NOTE BACKPUTE ASSEMBLY should be leveled horizontally and outlet box completely covered before final tightening to wall.

VIRING PROCEDURE

. Pull supply wires through WIREWAY OPENING and make conneofions

Blaak fixture lead (or fixture lead without tramr mark) to black supply Ieact white fixture lead (or fixture lead with tracer mark) to white supply wire.

Uninaulstad wire is a GROUND WIRE and must bernnneciad to agroundkrgtarminal or ground wire in the OUTLET SOX, Use wire nuts (local hardware

item), Push the”splisea into the OUTLET BOX.

!,Raiae, FIXTURE ASSEMBLY and align MOUNTING STUD HOLES and SOCKET HOLES with SOCKETS and MOUNT STUDS on BACKPMTE. Gently

slide FIXTURE ASSEMBLY backwards until the MOUNTINGSTUDSprotrudethroughtheholesin FIXTUREASSEMBLY,Secureinplacewith

BAITERY NUTS provided.

CAUTION: MAKE CERTAIN THAT NO WIRES ARE PINCHED BETWEEN THE BACKPlATE ASSEMBLY AND THE FIXTURE ASSEMBLY.

1.From top of fixture, position DIFFUSER DISHES over shsular openings (ss shown in Fig. 4) and gently lower until dishes sit securely in each opening.