INSTRUCTION MANUAL
CD/MP3 Boombox with AM/FM Radio and Cassette Recorder
SX-2718MR
DEAR CUSTOMER
Congratulations for your purchase!
Please read this manual carefully, and keep it for future reference.
If you need extra support, please write to [email protected]
Pagina 1
WARNING
TO PREVENT ELECTRIC SHOCK; DO NOT USE THIS PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES
CAN BE FULLY INSERTED TO PREVENT BLADES EXPLOSURE.
TO PREVENT FIRE OR SHOCK HAZARD; DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRONICS
SHOCK
DO NOT OPEN
The lighting flash with arrowhead
symbol, with an equilateral triangle
is intended to alert the user to the
presence of un-insulated
dangerous voltage within the
products enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
CAUTION: TO REDUCE
THE RISK OF ELECTRIC
SHOCK, DO NOT
REMOVE COVER (OR
BACK). NO USER
SERVICEABLE PARTS
INSIDE REFER
SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
The exclamation point within
an equilateral triangle is
intended to alert the user to
the presence of important
operating and maintenance
(servicing) instruction in the
literature accompanying the
appliance.
LASER SAFETY
This unit uses a laser. Only a qualified service
person should remove the cover or attempt to
service this device to avoid possible eye injure.
Caution: USE OF CONTROLS OR ADJUSTMENT
OF PERFORMANCE OF PROCEDURE OTHER
THAN SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
DANGER:
INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCK
FAILED OR DEFEATED. AVOID
DIRECT EXPOSURE TO LASER
BEAM.
Pagina 2
LOCATION OF CONTROLS
1. Volume control knob 17. speaker
2. CD door open button 18. CD folder up button
3. Carry handle 19. CD skip up button
4. FM antenna 20. CD skip down button
5. Cassette stop button 21. Power indicator
6. Cassette play button 22. LCD display
7. Cassette F.F. button 23. Cassette compartment
8. Cassette rewind button 24. Function switch
9. Cassette record button 25. FM stereo indicator
10. Cassette eject button 26. Band switch
11. CD door 27. Stereo headphone jack
12. CD play/pause button 28. Battery door
13. CD mode button 29. AC socket
14. CD stop button 30. AUX/MP3-in jack
15. Dial pointer 31. Voltage selector
16. Tuning knob 32. Remote sensor
Pagina 3
AC OPERATION
Connect the plug to the AC socket of the unit and the other end to a standard AC outlet.
ATTENTION
1. Do not plug or unplug the power cable while you have wet hands;
2. When planning not to use this unit for a long time, disconnect the power cable from the wall outlet;
3. When disconnecting the power cord from the wall outlet, do not pull on the cord in order to avoid shock risks
caused by damaged cable.
BATTERY OPERATION
Disconnect the AC Cord Set completely. Open the Battery Compartment Door and insert 6 pieces UM-2 "C" size
batteries into the battery compartment with battery polarity as shown inside the battery compartment.
NOTE : To turn off the unit, set the function switch to TAPE position
RADIO OPERATION
1. Set the function switch to RADIO position.
2. Set the Band Switch to the "AM" or "FM" position.
3. Turn the Tuning Knob to your desired radio station.
4. Adjust the sound level by rotating the Volume Control Knob.
5. To turn off the radio, set the function switch to TAPE position.
FM STEREO INDICATOR
When turn to a FM stereo broadcast the "FM ST." LED Indicator will light up.
ANTENNA
For best reception, fully extend the FM Antenna to receive FM stations. For AM reception, the unit has a
built-in antenna, turn the whole unit for best reception.
CASSETTE OPERATION
Tape Playback
1. Press the Eject Button to open the cassette door, insert a cassette tape into the Cassette Compartment and
push the cassette door to close.
2. Slide the Function Switch to Tape position and press the Play Button to start playing the tape.
3. Adjust the Volume Control Knob to your desired volume level.
4. To stop the tape, simply press the Stop Button.
Fast Forward and Rewind
The tape can be fast forward or rewind by pressing the Fast Forward Button or Rewind Button respectively.
Auto Stop System
When the tape runs to its end during playback or recording, the cassette operation will be stopped automatically.
CAUTION: To avoid damage to the cassette mechanism or to the cassette tape, always press the Stop Button
between each operation
Pagina 4
RECORDING FROM THE RADIO
1. Tune to desired radio program as described in the "Radio Operation" section.
2. Insert a blank cassette tape into the Cassette Compartment.
3. Press the Record Button and the Play Button simultaneously to start recording. With the built-in Automatic
Level Control (ALC), the best recording quality is automatically adjusted. Changing the volume level will not
affect the recording.
4. To stop recording temporarily, press the Pause Button. To continue the recording, press the Pause Button
once again.
5. Press the Stop Button to stop recording.
6. When the tape runs to its end, the cassette operation will be stopped automatically.
CD/MP3 OPERATION
Playing a Compact Disc
1. Set the Function Switch to CD/MP3 position. Open the CD compartment by pushing the CD door open button.
2. Put a CD into the compartment and close the CD door.
3. The unit will start reading the disc and the total number of tracks in the entire disc will display.
4. If Play/Pause Button is pressed during stop mode, the first track will be played.
5. If Play/Pause Button is pressed during play mode, the CD will go to pause mode and pause signal will be
shown on.
6. If Stop Button is pressed during play or pause mode, the CD will go to stop mode and display total no. of track.
Playing a MP3
1. Insert a MP3 disc into the CD compartment and close the door.
2. The unit will start reading the disc and the total number of tracks in the entire disc will display.
3. If Play/Pause Button is pressed during stop mode, the first track will be played.
4. Press Folder UP Button to select the album you want to listen.
5. To stop play, press the Stop Button
Skip Mode
1. During play or pause mode, if Skip up Button is pressed, it will go to next track and display the track no.
and then continue play or pause mode.
2. During play or pause mode, if Skip down Button is pressed, it will go back to the beginning of the track,
same track no. is display and CD continue the play or pause mode.
3. After step 2, press Skip down Button again, it will go to the previous track and continue the play or pause
mode.
Different Play Mode
Mode Button can be pressed during play to accomplish many different kinds of play.
Pagina 5
Programming (operates by remote control only)
In case of CD Disc
1. Set in CD/MP3 mode. (Please ensure unit in CD stop mode)
2. Press the Program Button on the remote, display will flash.
3. Select a desired track by using the Skip Buttons.
4. Press the Program Button to enter the track into setting.
5. LCD display changes to 02.
6. Repeat step 3-4, up to 20 tracks can be programmed in any order.
7. Press Play Button once to start playing the first track of your programmed list.
8. Press Stop Button once to cancel the programming.
In case of MP3 Disc
All procedure is same as normal disc. But if you have directory in your disc, you have to select directory and track
both. You can program up to 20 songs with above method.
RECORDING FROM CD/MP3 PLAYER
1. Slide the Function Switch to "CD/MP3" position.
2. Put a CD or MP3 disc into the CD compartment with the label on top.
3. Insert a blank cassette into the Cassette compartment and press Pause Button of the cassette deck.
4. Press Record Button and Play Button simultaneously of recording stand-by. With the built-in ALC, the best
recording quality is adjusted.
5. Activate the CD player, playing in a desired track as described in the CD Player Operation section. Release
the Pause Button of the cassette deck to start recording.
6. To temporary stop recording, press the Pause Button. To continue recording, press the Pause Button again.
7. Press Stop Button of the cassette deck to stop recording, then stop CD playback by pressing CD Stop Button
of the CD player.
REMOTE CONTROL
Open the Battery Compartment Door and insert two pieces "AA" size batteries into the battery compartment with
battery polarity as shown inside the battery compartment.
Point the remote control at the remote sensor. The functions of the buttons on the remote control are same as the
corresponding controls on the main unit.
1.
Stop Button
2.
Program Button
3.
Mode Button
4.
Folder Up Button
5.
Folder Down Button
6.
Play / Pause Button
7.
Skip Up Button
8.
Skip Down Button
9.
Battery Compartment
Warning:
When the remote will not be used for a long time, remove the batteries in order to prevent damage due to
electrolyte leakage.
Pagina 6
STEREO HEADPHONE JACK
For private listening, insert the plug of a stereo headphone into the Stereo Headphone Jack and adjust the
Volume Control Knob accordingly. During the use of a headphone, the speakers are automatically disconnected.
AUX/MP3-IN CONNECTION
1. Insert the audio cable into the Line Out Jack or Phones Jack on your MP3 Player/iPod. Another ends inserts
into the corresponding AUX/MP3-IN Input Jack on your main unit;
2. Turn on your main unit and slide the Function Selector to AUX/MP3-IN position;
3. Make sure your device in component is turned on, and follow your component’s instruction;
4. To stop this function, simply slide the Function Selector to Tape position.
CARE AND MAINTENANCE
Precautions
1. Always turn off the unit after use.
2. Keep the unit away from magnetic objects, water or heat sources.
3. Use a clean soft cloth moistened with lukewarm water to clean the cabinet. Never use chemical cleaners that
could damage the finish of the unit.
4. Never touch the CD pickup and lens. If fingerprints get on the pickup lens, clean it gently with a commercial
lens cleaner.
5. Disconnect the unit from any power sources before cleaning.
Note:
Because of none-standardized format definition/production of MP3 CD, playback quality & performance are not
guaranteed.
Manufacturer is not responsible for the playability of MP3 in any case due to recording conditions such as PC
performance, writing software, media ability and etc.
SPECIFICATIONS
Frequency Range: AM 540 - 1600 KHz
FM 88 - 108 MHz
Power Supply: AC 110/220V ~ 60/50 Hz
DC 9V
(UM-2 x 6)
ATTENTION : The unit may be submitted to changes in specifications, characteristics and/or operation without
prior notice to the user, in order to continue improving and developing its technology.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Lenoxx CD815 User manual
-
Califone 1886 User manual
-
Califone 2455AV-03 User manual
-
Califone MP3 Player 2385-03 User manual
-
Akai QXD5370 Owner's manual
-
jWIN JX-CD492 User manual
-
Califone 2385AV-03 User manual
-
JVC RC-EX16B User manual
-
HamiltonBuhl 5050ULTRA Portable CD Cassette Player User manual
-
