2. Troy-Bilt
  3. 31AS62N2711
31AS62N2711

Troy-Bilt 31AS62N2711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 31AS62N2711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • How do I install the chute assembly?
    How do I prepare the snow thrower before starting?
    How do I start the engine?
778-11820B© 2013 31AS62N2
Chute Assembly
Handle Knobs
Chute Adapter
Upper Handle
Chute
Directional
Control
Chute Bracket
Shift Lever
A. Place shift lever into F6
position.
B. Pivot upp er han dle into
operating position
C. Tighten handle knobs.
A
B
C
Place chute assembly
onto chute adapter.
Close the three
flange keepers.
Keepers will click
into place when
properly secured.
Remove flat washer and
hairpin clip.
Insert chute directional
control into chute
bracket.
Secure with washer and
clip.
1
3
2
4
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
Oil Fill /
Dipstick
Electric Starter
Button
Electric Starter
Outlet
Primer
Key
Throttle
Control
Choke
Control
Gas Fill
778-11820B© 2013 31AS62N2
Move throttle control into
the Fast position.
Move the choke control
into the Choke
position.
A. Connect an extension cord
to the electric starter outlet.
B. Plug the other end of the
cord into a three-prong
120-volt, grounded, AC
receptacle.
Push primer
three times.
Fill fuel tank with clean,
fresh gasoline. Do not fill
above the base of fuel
tank neck.
Check the oil level using
the dipstick. Add oil if
necessary. (Refer to the
Operator’s Manual)
Insert the key into the
key switch until the key
snaps into place.
Do not turn the key!
A. To start engine,
push the starter
button.
B. When engine
starts, slowly move
choke control
into the Run
position.
C. Disconnect cord
from power
receptacle fi rst and
then from snow
thrower’s outlet.
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U
/