Installation Instructions
Tools Required: Tape Measure, Screw gun (power drill) with #2 Phillips bit and Pliers
Measure the distance between the 16” on center studs. The inside distance between the studs must be 14 1/2" inches +/- 1/8”. If the distance is
more or less than this dimension, adjust the studs as required or shim between the bracket and the stud. Locate and install the UniBrackets and
Bracket Extensions as shown below. (Tip: Tap screws in place with a hammer then screw with a power drill). Visit www.the-cpg.com for
installation videos and helpful hints.
Small Shelf Installation Large Shelf Installation
Hanger Bar and Hooks Installation
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
DreamLine DL-6438R-01CL Installation guide
-
-
EZ Shelf EZS-SCRW72-1-1 Installation guide
-
MAAX 103415-304-516 Utile side wall 36 in. Installation guide
-
NewAge Products 40421 User manual
-
-
NewAge Products 40403 Operating instructions
-
DreamLine DL-6192R-01 Installation guide
-
Thermador PRD486JDGU Installation guide
-
