®
VAPORPROOF FIXTURE
Ceiling and Wallmount Installaon Instrucons
Thank you for buying Sunlite lighng fixtures. Our aim is to design the best quality products so you can get the job
done right. We’d like to hear your comments. Check out our website at www.sunshinelighng.com to contact us.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
Sunlite Fixtures must be wired in accordance with the Naonal Electrical Code and applicable local codes.
Proper grounding is required for safety.
WARNING: MAKE CERTAIN POWER IS OFF BEFORE INSTALLING OR MAINTAINING FIXTURE.
Use supply wire rated for 90°C.
The units are wired for 120V. Units built for a specific voltage are factory-wired for
the requested voltage. Make sure the supply voltage is compable with the unit.
LOCATION
Fixture should be located on wall or ceiling and not be recessed. Fixture must be
posioned with lamp facing down.
Not suitable for pendant mount.
MOUNTING & WIRING
1. Thread all leads through back of juncƟon box and gasket with at least 6” of lead showing.
2. Line up the juncƟon box to circuit box and mount securely to surface.
3. With gasket in place, aƩach juncƟon box to circuit box using 5/8” screws provided.
4. Connect the power lead to the black lead.
5. Connect the common lead to white lead.
6. Fixture ground wire must be connected to green grounding screw.
7. All unused leads must be capped and insulated with provided wire caps.
8. Install bulb (see max. bulb waƩage)
9. Screw in glass jar, aƩach cage, and Ɵghten with aƩached screw.
10. To insure weatherproof seal, make sure all holes (mounƟng, conduit, etc.) are sealed
with weatherproof silicone sealant.
IMPORTANT: FIXTURE MUST BE INSTALLED WITH LAMP BASE UP
CLEANING
Clean fixture and glass jar with nonabrasive glass cleaning soluon or detergent.
Rinse with clean water. Make sure fixture is dry before use.
RE-LAMPING
WARNING: Make certain power is off. Be sure fixture temperature is cool enough to touch.
Open fixture by unscrewing guard and jar from fixture. Prior to installing, check that the lamp is of proper type
and waage. Observe lamp manufacturer’s recommendaons on lamp operaon and burning posions.
THESE INSTRUCTIONS DO NOT COVER ALL DETAILS OR VARIATIONS IN EQUIPMENT,
NOR DO THEY PROVIDE FOR EVERY POSSIBLE CONTINGENCY TO BE MET IN
CONNECTION WITH INSTALLATION, OPERATION OR MAINTENANCE
BLACK
WIRES
WHITE
WIRES
POWER
IN
GLASS JAR
CAGE
GASKET
JUNCTION
BOX
Sunlite Manufacturing • Brooklyn, NY 11231 • Made in China
MAXIMUM BULB WATTAGE
VT100 & VTA100 100W A19
VT200 & VTA200 200W A21
-
1
Sunlite 04982-SU Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
STA-RITE Small Underwater Pool Lights SunLite LTC Owner's manual
-
Pentair Small Underwater Pool Lights SunLite LTC User manual
-
Carex SunLite Light Therapy Lamp User guide
-
American Lighting LW36-RGB Quick start guide
-
Advanced Lighting Systems eLum Cove RGB Installation Instructions Manual
-
ADJ mydmx GO Operating instructions
-
Astralpool IGNIA LIGHT DMX pro Owner's manual
-
-
Robe Cyber Arch™ User manual
-
Euri Lighting EUB-2150H Installation guide
