EK Water Blocks EK-FC Link BLANK Serial CSQ User manual

Category
Hardware cooling accessories
Type
User manual
All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use. Released on 19
th
of July, 2012.
Installation and mounting manual for EK-FC Link BLANK Serial CSQ
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com for updates. Before
installation of this product please read important notice, disclosure and warranty conditions published on www.ekwb.com .
STEP 1: PREPARING YOUR HARDWARE STEP 2: ATTACHING FC Link to the EK-FC Bridge (CSQ)
EK-FC Link BLANK serial is a product ment to close the unused
ports on any of EK-FC Bridge Serial CSQ products. However, it may
be replaced by an adequate EK-FC CSQ waterblock once user
acquires or decides to upgrade the system.
Below is sample picture of EK-FC Bridge Dual Serial CSQ. Please do not forget to secure
orings in the Bridge's groove. Make sure they are set properly and not pinched in any way.
If that condition is not met a leak may occur. A M4x25 DIN7984 screw is enclosed to EK-FC
Bridge.
All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use. Released on 19
th
of July, 2012.
Installation and mounting manual for EK-FC Link BLANK Serial CSQ
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com for updates. Before
installation of this product please read important notice, disclosure and warranty conditions published on www.ekwb.com .
STEP 1: PREPARING YOUR HARDWARE STEP 2: ATTACHING FC Link to the EK-FC Bridge (CSQ)
EK-FC Link BLANK serial is a product ment to close the unused
ports on any of EK-FC Bridge Serial CSQ products. However, it may
be replaced by an adequate EK-FC CSQ waterblock once user
acquires or decides to upgrade the system.
Below is sample picture of EK-FC Bridge Dual Serial CSQ. Please do not forget to secure
orings in the Bridge's groove. Make sure they are set properly and not pinched in any way.
If that condition is not met a leak may occur. A M4x25 DIN7984 screw is enclosed to EK-FC
Bridge.
EK-Bridge CSQ
Screw M4x25 DIN7984
Oring 13x1,5
EK-Bridge CSQ
Screw M4x25 DIN7984
Oring 13x1,5
  • Page 1 1

EK Water Blocks EK-FC Link BLANK Serial CSQ User manual

Category
Hardware cooling accessories
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI