4
FITTING/REMOVING ATTACHMENTS
1. Unplug the appliance before tting or removing attachments.
2. To t an attachment, push it on to the end of the motor unit, and turn it clockwise.
3. To remove the attachment, turn it anti-clockwise, then pull the attachment o the motor
unit.
USING
1. Put the plug into the power socket.
2. Press the low speed button for low speed, release it to switch o.
3. Press the high speed button for high speed, release it to switch o.
• Large quantities, thick mixes, and a high ratio of solids to liquids require longer timings and
slower speeds.
• Smaller quantities, thinner mixes, and more liquids than solids require shorter timings and
higher speeds.
WAND ATTACHMENT
Use the wand attachment to blend, pulp or purée ingredients in the pan or bowl you’re going
to cook them in.
Whatever container you use, make sure it’s on a stable, at surface, and support it with your free
hand to prevent it wandering over the work surface.
• Don’t immerse the wand past the top of the parallel-sided tube.
• When using it in hot liquids, don’t let the blade break the surface at an angle, as you might
spray liquid outside the bowl/pan/container.
• Don’t switch on till the blade is inside the food container.
• Switch o before lifting the blade from the food container.
WHISK ATTACHMENT
Use the whisk where you would have normally used a hand whisk.
• Push the whisk into the bottom of the whisk holder.
• To remove the whisk, simply pull it out of the bottom of the whisk holder,
• Don’t immerse the whisk past the bottom of the whisk holder.
CHOPPING ATTACHMENT
You can use the chopper as a mini food processor.
1. Unplug the motor unit.
2. Handle the chopping blade only by the plastic part. Lower it into the bowl over the spindle
in the bottom of the bowl.
3. Add the ingredients – don’t ll the bowl above the 700ml mark.
4. Fit the bowl lid – the top of the chopper ts into the drive in the underside of the lid.
5. Fit the motor unit to the top of the bowl lid.
6. Use the chopper in bursts of a few seconds, otherwise you risk overdoing it.
7. When nished, unplug the motor unit then remove it from the lid.
8. Lift the lid gently from the bowl – take care that any drips fall into the bowl. Lift out the
chopping blade.
9. For storage, you may use the non-slip base as a lid.