V-ZUG 284 Installation guide

Type
Installation guide

This manual is also suitable for

Installation instructions
Tumble-dryer tower with Pronto-Combi connection
One-family hausehold
J284.551
20.12.07 PUK
4/4
These installation instructions apply to the models: 284, 286
Validity
Installation
1. Remove cover A at rear.
2. Mount connector housing B to drain connector C and
screw firmly (moisten drain connector).
3. Place hose in retainer D.
4. Attach retainer D with hose to installation plate and secure
firmly with 2 screws (4 × 16).
5. Fit hose to connector housing and secure with clamp E.
ProntoCombi connection set: W5.0040
Screw rear levelling feet – where present – back as far as stop.
Preaparatory work on tumbledryer
6. Cut off cover F at socket, using a knife (marking).
7. Remove pump cover G.
8. Remove plug H from pump and insert in socket at position
provided.
9. Mount blanking plug J from the set on pump connector.
10. Mount cover K to pump cover G with 2 screws (3 × 9) and
then refit the pump cover to the tumble-dryer.
A
B
C
D
E
Cut off, using knife
View from below
View from rear
F
K
G
Plug in on other side
H
J
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

V-ZUG 284 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI