13
5
6
24
7
Installation
Sink Fitting
HD310170 SNK2100/2150
Measure and Cut
Fitting
1
2 3
4
5
6
Lay the sink face down and draw around the
edge. Use the measurements below as a guide.
WARNING: SHARP EDGES
Sink Outline
Wipe CleanCut around the inner line
Clip locations and order of
tightening with sink in position
Wipe away excess silicone
Note: Once tightened, brackets can be secured up into the underside of the worktop. Screws
are not supplied.
Fit brackets to the sink using the screws provided.
RH drainer tting shown
954mm
484mm
8mm
Silicone
Sealant