2. EPH Controls
  3. TA230
TA230

EPH Controls TA230 Installation guide

  • I have reviewed the installation instructions for the EPH Controls Thermal Actuator models TA230 and TA24. This document outlines important safety precautions, installation steps, and how to switch between normally closed and normally open settings. I'm ready to answer your questions about this device.
  • What is the factory setting of the thermal actuator?
    What should I do before changing from Normally Closed to Normally Open?
    What are the voltage options for the thermal actuator?
50
°C
-5
122
°F
23
90°
IP 42
E N60529
IP 44
E N60529
1
2
blue brown
bl br
TA230 - 230Vac
TA24 - 24Vac TA24 TA230
br bl
24V ~
h = s troke
U 24 V ~ 230 V ~
t 4,5 min. 3,5 min.
h 3,5 mm 3,5 mm
F 125 N 125 N
P 3 W 2,5 W
I max 250 mA 150 mA
For use in normal environments.
TA2_ Thermal Actuator Installation Instructions
Page 1 of 2
Disconnect the power supply from any defetive appliances.
Factory setting is (NC) Normally Closed
Guidelines for the electrician; Level of contamination 2; As per EN60730
When changing from normally closed to normally open, live components are exposed.
Therefore, disconnect the power when changing.
CAUTION! Do not use if cable is defective.
1
3
5
4
2
20221020_TA2_InsIns_PK
EPH Controls Ireland
technical@ephcontrols.com www.ephcontrols.com
EPH Controls UK
technical@ephcontrols.com www.ephcontrols.co.uk
For use in normal environments.
Installation Instructions
Page 2 of 2
To reset to (NC) Normally Closed
To set to (NO) Normally Open
1
2
black
60 °
1
23
230V?
2mm
1
2
white
2
1
60°
1
23
230V?
1
2
3
TA2_ Thermal Actuator
6
7
6.1
6.4
7.1 7.2 7.3 7.4
6.5 6.6
6.2 6.3
20221020_TA2_InsIns_PK
EPH Controls Ireland
technical@ephcontrols.com www.ephcontrols.com
EPH Controls UK
technical@ephcontrols.com www.ephcontrols.co.uk
/