2. NavTool
  3. NTV-KITxxx
NTV-KITxxx

NavTool NTV-KITxxx User guide

  • Hello, I've reviewed the NavTool Interface user guide. This document details the connection process for the interface, including how to set the switches, connect audio and video inputs/outputs, and connect the microphone. I'm ready to answer any questions you have about these instructions.
  • How do I set the switches for the ON position?
    What does the AUX input depend on?
    How many camera inputs does the interface have?
1
+12V Manual Activation Input
+12V Output
Left Audio Output
Right Audio Output
Left Camera Input/ Video Input 3
Right Camera Input/ Video Input 4
Front Camera Input/ Video Input 2
Rear Camera Input/ Video Input 1
(Not Used)
Click
Click
AUX Input depends on the type of jack
installed in your car from the factory
Or
2
1
Click
Click
Click
Click
Click
Click
Factory Wire
- OFF Position - Both Switches Up
- ON Position - Both Switches Down
Switch 1 Set to ON - ON is Down
Switch 2 Set to ON - ON is Down
ON 1 2
ON 1 2
Click
See Part 2
(Not Used)
NavTool Supplied Cable
NavTool Supplied Cable
NavTool Supplied
Microphone
NavTool Supplied Box
NavTool Interface
NavTool Supplied Harness
NavTool Supplied Cable
Back of Car Radio
Quick Connection Guide Part 1
2
Click
Click Click
Click
*2
Close Up View of Radio Connectors
*2- Cable that previously used to be
connected to gray connector in the
back of the radio
NavTool Supplied LVDS Cable
NavTool Supplied LVDS Cable
Factory LVDS Cable
See Part 1
NavTool Interface
Back of Car Radio
Quick Connection Guide Part 2
/