2. Baby Lock
  3. EMB7-CLF
EMB7-CLF

Baby Lock EMB7-CLF Operating instructions

  • Hello! I've reviewed the user manual for the Baby Lock EMB7-CLF clear cloth presser foot. This document provides instructions on how to install the new presser foot and ensures proper needle positioning. I'm ready to answer your questions about its installation or functionality.
  • What should I do before installing the presser foot?
    How do I remove the old presser foot?
    What should I check after installing the new foot?
800-422-2952 www.babylock.com
1. Set needle bar in the full up right position.
2. Raise presser foot lever.
3. Loosen 2.0 mm (allen screw) from cloth presser foot.
4. Remove cloth presser foot from presser bar.
5. Insert new clear presser foot onto the presser bar, all the way up.
6. Make sure the allen screw is facing the at side of the presser bar,
then tighten screw.
Important: After installing the new cloth presser foot, rotate the
handwheel slowly by hand to ensure that the needles are correctly
positioned and centered in the cloth presser foot openings. If not,
loosen the 2.0 mm allen screw on the cloth presser foot, adjust the
position and retighten the screw.
Clear Cloth
Presser Foot
for Embellisher
(EMB7-CLF)
Instructions
Baby Lock
Serger Accessories
LNIS-EMB7CLF
/