8/29/22, 1:38 PM
Belkin Official Support - How to set up your Belkin BOOST↑CHARGE™ PRO 3-in-1 Wireless Charger with MagSafe, WIZ009
https://www.belkin.com/us/support-article?articleNum=317815
1/2
The Belkin BOOST↑CHARGE™ PRO 3-in-1 Wireless Charger with MagSafe, WIZ009 features an
ultraconvenient 3-in-1 wireless charging stand that delivers the fastest possible charge of up to 15W for
iPhone® 12 and iPhone 13 models.
The Belkin WIZ009 includes a 40W AC power adapter that is capable of charging all your devices at the same
time. At the end portion of this adapter is a right-angle barrel connector that plugs into the base of your
charger.
The base of the charger features a precision cut slot where you can plug in the AC adapter. This slot helps
lock the connector to the Belkin WIZ009, allowing it to be held securely and reducing the likelihood of
accidental disconnection.
To connect the power adapter to the charger, you will need to hold the stand so that the bottom is facing you
and the power plug slot is at the bottom.
The steps below will show you how to set up your wireless charger:
NOTE: Before using the charger, make sure to remove first the plastic protection film from the charging dock.
Step 1:
Place the barrel connector into the slot with the metal tip pointing to the left. Push the connector into
the plug on the left-hand side of the slot.
Step 2:
Once connected, rotate the cord down into the cord slot. This will hold your cord securely and keep
your stand from becoming accidentally unplugged.
How to set up your Belkin BOOST↑CHARGE™ PRO 3-in-1 Wireless Charger
with MagSafe, WIZ009
8/29/22, 1:38 PM
Belkin Official Support - How to set up your Belkin BOOST↑CHARGE™ PRO 3-in-1 Wireless Charger with MagSafe, WIZ009
https://www.belkin.com/us/support-article?articleNum=317815
2/2
© 2022 Belkin International, Inc.
/
