8 Inch

Opera 8 Inch Installation guide

  • Hello! I've reviewed the Installation and User Guide for the Opera Classic Bed 8" Extension Platform. This document provides clear instructions on how to install the platform to extend the length of Opera Classic Profiling beds by 8 inches. The guide details the necessary tools, the process of attaching the platform, and safety precautions. I'm ready to answer your questions about the extension platform.
  • What bed is the Extension Platform compatible with?
    What tools are needed for installation?
    How much does the extension platform increase the bed's length?
Installation and User
Guide
VISIT OPERABEDS.COM | CALL 0333 222 8584
Enhancing Lives,
Delivering Comfort
OPERA® CLASSIC BED 8”
EXTENSION PLATFORM
1 | Opera Beds | Opera Classic Bed 8” Extension Platform Installation and User Guide | Version 1
Before you begin! We recommend that two people install this bed
extension platform to avoid injury - Observe the general manual
handling guidelines.
2. Installation and Commissioning
(A) Extension Platform
Contents
1. General Information and Safety
The Opera Classic Bed 8” Extension Platform is designed to extend the Opera
Classic Profiling Bed by 200mm (8”) for taller users.
The Opera Classic Bed 8” Extension Platform is designed to be used with the
Opera Classic Profiling beds. Opera will not be liable for any hazards, injury
or damage arising from using the extension platform incorrectly or with a
dierent bed.
Any incidents or issues must be reported to Opera at, support@operabeds.
com.
Before you begin, you will also need:
Tools: 3mm Allen Key, A cross head screw driver.
operabeds.com | 0333 222 8584 | 2
1. Remove the Footboard
Firstly, the footboard actuator will need to be removed from the control box
to prevent damage. Pull up the back rest platform and remove the socket
cover by loosening the screws and removing the cover. The footboard
actuator can then be disconnected from the control box.
The side rails will then be removed by loosening the side rail screws with an
allen key and detaching the side rail. The side rails can then be laid on the
oor.
To remove the footboard pull and twish the black thumb screws on the
footboard so that they are in the unlocked position. Detach the footboard by
pulling the lower bed platform upwards and setting the footboard to the side.
3 | Opera Beds | Opera Classic Bed 8” Extension Platform Installation and User Guide | Version 1
2. Attach the Extension Platform
Attach the extension platform to the leg rest platform by pulling the leg rest
platform upwards and placing it onto the extension platform.
Secure in place by tightening the black thumb screws on both sides of the
bed.
operabeds.com | 0333 222 8584 | 4
3. Attach the Footboard
Attach the footboard to the end of the mattress leg rest platform by lifting up
the bed platform and ligning it up with the footboard brackets.
Twist the black thumb screws so that they are in the locked position.
Plug the actuator cable back into the control box. Attach the side rails and
tighten the side rail screws.
Ensure that all thumb screws are correctly in place and in their locked
position before using the bed.
5 | Opera Beds | Opera Classic Bed 8” Extension Platform Installation and User Guide | Version 1
Notes
operabeds.com | 0333 222 8584 | 6
Notes
7 | Opera Beds | Opera Classic Bed 8” Extension Platform Installation and User Guide | Version 1
Azure House, Connaught Road, Kingswood, Hull, HU7 3AP
0333 222 8584 | support@operabeds.com | operabeds.com
Version 1 | Published in October 2022
/