1. Associate the video function with the system

Step 1: Install and activate the TYDOM 2.0

(see user guide)

Step 2: Associate the TYDOM 2.0 with the system

Ê Enter the installer code (123456, by default) and confirm with OK.

Ë Press Settings, select the menu:

Installation > Products, then confirm with OK.

Ì Select "Add", then confirm with OK.

The alarm control unit's red LED switches on.

from the CLT 8000 TYXAL+ touch screen keypad.

Step 3: Associate the DMBV TYXAL+ to the system

Ê Enter the installer code (123456, by default) and confirm with OK.

Ë Press Settings, select the menu:

Installation > Products, then confirm with OK.

Ì Select "Add", then confirm with OK.

The alarm control unit's red LED switches on.

• The alarm control unit must be in maintenance mode.

• The alarm control unit must have a CLT 8000 TYXAL+ touch screen keypad

associated to programme the mobile phone numbers (SMS).

ADDITION - Video function

The video function of the alarm system is provided by an infrared motion detector and DMBV TYXAL+ video associated

with a TYDOM 2.0 transmitter. These 2 products must also be associated with the system.

If an intruder is detected, an alarm is triggered and takes a 5-second video. A link to play this video is automatically

sent by SMS to the number or numbers programmed in the CLT 8000 TYXAL+ touch screen keypad.

Téléchargement

Programmation

Codes d'accès

Version logicielle

Réglages

Appuyer sur la touche

Retour

Ajouter

Code d'accès

XXXXXX

Ok

SOS

1

2

3

25/11/14 12:48

SOS

Í Briefl y press the product button.

The LED fl ashes when the button is pressed, then fl ashes again to confi rm the

association (the association phase can last up to 12 seconds).

The alarm control unit beeps. The TYDOM 2.0 beeps.

• Choose the detector triggering mode (immediate or delayed).

In the case of a delayed triggering of the DMBV, the video will be recorded as

soon as an intrusion is detected, but will only be transmitted if it is confi rmed.

3. Test the video function

Ê Enter the installer code (123456, by default) and confi rm with OK.

Ë Press Settings, select the menu:

Installation > Test, then confi rm with OK.

Ì Select the type of product to test: Detector, and confi rm with OK.

Í Press the button of the TYXAL+ DMBV detector twice and