Little Wonder 60050 Owner's manual

Brand
Little Wonder
Model
60050
Type
Owner's manual
FELT BAG LINER KIT
ASSEMBLY INSTRUCTIONS
CONNECT MATING VELCRO
SIDES ON THE BACK
OF COLLECTOR
CONNECT MATING VELCRO
SIDES ON THE FRONT
OF COLLECTOR
© 2005 Little Wonder, Div. of Schiller-Pfeiffer Inc. All Rights Reserved.
Contents of Felt Bag Liner Kit Include:
Felt Bag Liner (600197)
Velcro Hook Strip (600161)
Instructions (600711)
The Felt Bag Liner (600197) is designed to work in conjunction with the Debris Bag and Band Clamp
(600176 & 600177) to filter out dust and small particle of debris from the discharge air stream of the
HPV vacuum. Included with the Felt Liner is a Velcro Hook Strip (600161). The Felt Liner has a Velcro
Loop Strip sewn on each side to help hold it in place.
Directions
(600050)
1. Remove the Debris Bag from the Collector.
2. Clean the back area of the Collector above
the lip to remove any dirt and debris with a
damp cloth and allow it to dry thoroughly.
3. Peal off the backing to the Velcro Hook Strip
and attach it to the back of the collector
directly above the lip.
4. Attach one side of the Felt Liner to
the Velcro Hook Strip on the front of
the Collector.
5. Pull the Felt Liner over the lip of the
Collector and attach the Velcro on the
opposite side of the Felt Liner to the back
of the Collector.
6. Slip the Debris Bag over the Felt Liner
and latch the Band Clamp over the lip of
the Collector. Adjust the wire form on the
Band Clamp as required for a secure fit.
It may be necessary to remove the “Seal
Strap” from the Debris Bag in order to
close the Band Clamp.
LITTLE WONDER®
DIVISION OF SCHILLER-PFEIFFER, INCORPORATED
1028 STREET ROAD, P.O. BOX 38
SOUTHAMPTON, PA 18966
PHONE 877-596-6337 • FAX 215-357-8045
www.littlewonder.com
Specifications, descriptions, and illustrative material in this literature are as accurate as known at the time of publication, but are subject to change without notice.
P/N 600711
10/05
877-LWONDER
Directions:
Do not use Felt Liner when vacuuming wet debris; this will dramatically decrease the airflow through
the system.
Expect some amount of suction loss when using the Felt Liner.
Alternate the front/back orientation of the Felt Liner when it is attached to the Collector to maximize the
wear life of the part.
Periodically turn the Felt Liner inside out before attaching it to the Collector. This will help to clean out the
pores of the fabric and minimize suction loss of the machine.
  • Page 1 1
  • Page 2 2

Little Wonder 60050 Owner's manual

Brand
Little Wonder
Model
60050
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents