Long Silicone Light RGB GL10M Installation Manual
We will appreciate for your purchase of 'Long Silicone Light'. Please use this manual and install correctly and safely.
※ May not ship with endcap and adhesive such as custom specification products.
□ If you have any questions about this product,
please contact our sales offices as below.
ATEX CO.,LTD
Hikaren Building No.B, 2-3-20, Toukou, Hakata-Ku, Fukuoka-City,
Fukuoka, 812-0008,Japan
TEL +81-92-414-8708 FAX +81-92-414-8709
URL http://www.atex-jp.com
Advanced Technology Expert America Inc.
386 Beech Ave. #B1, Torrance, CA 90501, USA
TEL +1-310-328-4131 FAX +1-310-787-0837
Advanced Technology Expert International Pte Ltd
25 Tagore Lane #03-11, Singapore Godown, Singapore 787602
TEL/FAX : +65-6459-3211
The warranty is valid for 1 year after the delivery.
When installing Long Silicone Light,
they can be used with Aluminium Channel.
MAX. R30 mm (Length direction)
Long Silicone Light RGB COLOR
The power switch must be turn off when performing
installation or removal.
Please do not miswire the polarity of power supply. It will
cause problems.
Please be careful that eyes might be hurt when you look
straight at light emitting part.
When installed in a closed device, ambient temparature
must be -10 to 55℃.
Please be careful about static electricity.
It will damage LED's.
Please note that there is some variation in color among
LED's.
Power Supply voltage is 24Vdc only.
Please do not apply other voltage such as AC100 to
230V. It will cause fume or fire.
It is indoor/outdoor use. It can not be used at the
following places,such as "Under watar " "High humidity
and High temperature""Atomosphere of corrosive gas
""Damage from salt breeze".Because it will cause fume.
When bending horizontaly , minimum allowable Bending
Radius is 30mm.
It is not allowed to bend verticaly. It will cause cracks at
the solder points.
W88.8 (13)×H 15.5 (19.7) ×L mm ( ) size of ends
Red,Green,.Blue and synthetic colors