Astonica 50105222 User manual

Type
User manual

This manual is also suitable for

OUTDOOR LIVING
Read the instructions and precautions before use of this product
MODEL NO: 50105221
Please keep this instruction manual for future reference
3 - PIECE BISTRO SET
Instruction Manual
Made in China
©2004 Distributed by:
World Factory, Inc.
®
Southlake, TX 76092
Limited Warranty
World Factory, Inc.® Products for Home Use
World Factory, Inc.® (Seller) warrants to the original Buyer only, that each Astonica™ Product will be free
from defects in material and workmanship for a period of one (1) year from date of purchase. SELLER’S
SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL
BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH ARE DEFECTIVE IN
MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE SELLER WHICH HAVE BEEN
MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY FROM REPAIRS OR
ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER MAINTENANCE, NEGLECT
OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This warranty does not apply to
damage, heat-induced coloration changes, scratching or alteration due to normal use or weathering. To
make a claim under this Limited Warranty, you must return the complete product, transportation prepaid, to
any World Factory, Inc.® authorized service center. Call 1-888-422-7800 for the location of the nearest
authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1) YEAR
FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF PROFITS,
ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such provision
shall not affect any other provision herein, this Limited Warranty shall be construed as if such invalid and/or
unenforceable provision had never been contained herein.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all prior
agreements, arrangements, or understandings between the parties relating to product warranty.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
A 2Chair Back
B 2Chair Seat
C 8Chair leg
D
1
Table Top
Center Ring
E
1
Table Leg
F
3
Washer
G
29
Screw
H
3
Nut
I
29
A
B
C
D
E
F
G
H
I
Carefully remove the contents from the package. If any parts are missing do not attempt to
use the product until they have been obtained and correctly installed.
Caution: Do not over tighten fasteners.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-422-7800.
C
B
A
H
G
H
G
H
G
D
F
F
F
G
G G G
H H
H
H
I
I
G
H
G
H
G
H
E
1. (See Figure 1) Insert studs on chair back (A)
through holes in chair seat (B) and secure
with flat washers (G), and nuts (H).
2.Insert studs on one chair leg (C) into chair
seat (B) and secure with flat washers (G)
and nuts (H). Repeat for the other three
legs (D).
3.(See Figure 2) Place table top (D) upside
down on a flat non scratch surface. Attach
three legs (F) to the outside edge of
table top (D) and secure with flat washer (G)
and hex nuts (H).
4.(See Figure 3) Position center ring (E) over
tabs on legs (F) and secure with screws (I),
flat washers (G) and nuts (H).
5. Tighten all fasteners securely.
Figure 1
Figure 2
Figure 3
  • Page 1 1
  • Page 2 2

Astonica 50105222 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI