IKEA HOO S00 S Program Chart

Brand: IKEA

Model: HOO S00 S

Category: Cooker hoods

Type: Program Chart

This manual is also suitable for

IKEA HOO S00 S is a versatile kitchen appliance that can be used for both air extraction and filtration. It features three speed settings to adjust the extraction power according to your cooking needs, and halogen bulbs to illuminate your cooking area. The grease filter is removable and washable, and the carbon filter can be easily fitted to remove odors. The telescopic flue allows you to adjust the height of the hood to suit your kitchen layout.

5019 618

33021



HOO S00 - HOO S10 - HOO S40

INSTALLATIONSANGABEN

Mindestabstand zur Kochfläche: 50 cm (Elektroplatten), 75 cm (Gas-, Öl-,

Kohlekochplatten). Befolgen Sie bei der Installation die Nummerierung (1

.....)

und die jeweiligen Anleitungen. Schließen Sie das Gerät erst nach erfolgter Installation

an die Stromversorgung an.

Achtung! Das Auslassrohr und die Befestigungsmanschetten sind nicht im

Lieferumfang inbegriffen und müssen gesondert erworben werden.

INSTALLATION SHEET

Minimum height above cooker: 50 cm (electric cookers), 75 cm (gas, gas oil or coal

cookers). To assemble follow the numbers (1

.....) and relative instructions. Do

not connect the appliance to the electrical power supply until installation is

completed.

Warning! The exhaust pipe and clamps are not supplied and must be bought

separately.

FICHE D'INSTALLATION

Distance minimale par rapport à la cuisinière: 50 cm (cuisinière électrique), 75 cm

(cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la numérotation

.....) et les instructions correspondantes. Ne branchez pas l'appareil tant

que l'installation n'est pas terminée.

Attention ! Le conduit d'évacuation et les colliers de fixation ne sont pas fournis et

doivent être achetés à part.

INSTALLATIEKAART

Minimumafstand tot het kooktoestel: 50 cm (elektrische kooktoestellen), 75 cm

(kooktoestellen op gas, olie of kolen). Volg voor de montage de nummering

.....) en de bijbehorende aanwijzingen. Geef het apparaat geen stroom

totdat de installatie geheel voltooid is.

Let op! De afvoerbuis en de klembanden worden niet bijgeleverd en moeten apart

worden aangeschaft.

FICHA DE INSTALACIÓN

Distancia mínima desde los quemadores: 50 cm (fuegos eléctricos), 75 cm (fuegos de

gas, gasóleo o carbón). Para efectuar el montaje siga la numeración (1

.....) y

las instrucciones. No enchufe el aparato hasta que su instalación no esté terminada.

¡Atención! El tubo de descarga y las guías no están incluidas y se compran aparte.

FICHA DE INSTALAÇÃO

Distância mínima dos fogões: 50 cm (fogões eléctricos), 75 cm (fogões a gás, óleo ou

carbono). Para a montagem, siga a numeração (1

.....) e as respectivas

instruções. Não ligue o aparelho à corrente eléctrica até a instalação estar concluída.

Atenção! O tubo de descarga e as braçadeiras de fixação não são fornecidas e devem

ser compradas à parte.

61833021.fm Page 1 Monday, March 1, 2004 2:19 PM

5019 618

33021

HOO S00 - HOO S10 - HOO S40



SCHEDA INSTALLAZIONE

Distanza minima dai fuochi: 50 cm (fuochi elettrici), 75 cm (fuochi a gas, gasolio o

carbone). Per il montaggio seguire la numerazione (1

.....) e le istruzioni

relative. Non dare corrente all’apparecchio finchè l’installazione non è totalmente

completata.

Attenzione! Il tubo di scarico e le fascette di fissaggio non sono fornite e vanno

acquistate a parte.

ùüùü+ùùùþ

ü$12.)12.1.)2"0120"FP02!"0120"FP0120".0! #

02!0. #0! # +.22  21.   #1202.!1







.2"1$02" /0"2! 3 / 2020002!)!0*.21#10#!2

 !&12"0.212.1"

! 1 $1&."..&".2. !.120!&1"/0/.202..!0.

. 2 *$&!12

INSTALLATIONSBLAD

Minsta tillåtna avstånd från olika typer av spisar: 50 cm (elektrisk spis), 75 cm (gasspis,

gasolspis och koleldad spis). Följ givna anvisningar och anvisad nummerordning

.....) när fläktkåpan skall monteras. Slå inte på strömmen till fläktkåpan

förrän installationen är helt avslutad.

Utsläppsröret och rörklämmorna som krävs för installationen levereras inte

tillsammans med fläktkåpan, utan måste köpas separat.

INSTALLASJONSVEILEDNING

Minimumsavstand til komfyrtopp: 50 cm (elektriske kokeplater), 75 cm (gass-, parafin-

eller kullkomfyr). Følg nummereringen ved montering (1

.....), samt

monteringsanvisningene. Apparatet må ikke tilkobles strømnettet før installasjonen

er helt avsluttet.

Merk! Avtrekksrøret og klemmene følger ikke med og må bestilles separat.

INSTALLATIONSVEJLEDNING

Minimumafstand fra kogezoner: 50 cm (elkogezoner), 75 cm (gas-, olie- eller kulfyrede

kogezoner). Ved montering skal man følge vejledningens nummerrækkefølge

.....) og de tilhørende instruktioner. Apparatet må ikke tilsluttes

elforsyningen, før installationen er fuldført.

Advarsel! Aftræksrøret og spændebåndene leveres ikke med emhætten og skal købes

separat.

ASENNUSOHJEET

Vähimmäisetäisyys liedestä: 50 cm (sähkölevyt), 75 cm (kaasu-, öljy- tai hiililiedet).

Suorita asennus numerojärjestyksessä (1

.....) ohjeiden mukaisesti. Älä kytke

laitetta sähköverkkoon ennen kuin kokoonpano on kokonaan suoritettu.

Huomaa! Poistoputkea ja kiinnittimiä ei toimiteta laitteen mukana, vaan ne on

hankittava erikseen.

FIN

61833021.fm Page 2 Monday, March 1, 2004 2:19 PM

5019 618

33021



HOO S00 - HOO S10 - HOO S40

61833021.fm Page 3 Monday, March 1, 2004 2:19 PM

5019 618

33021

HOO S00 - HOO S10 - HOO S40



61833021.fm Page 4 Monday, March 1, 2004 2:19 PM

5019 618

33021



HOO S00 - HOO S10 - HOO S40

61833021.fm Page 5 Monday, March 1, 2004 2:19 PM

5019 618

33021



HOO S00 - HOO S10 - HOO S40

Preliminary information for installing the hood:

Expansion plugs are provided to secure the hood to most types of ceilings. A qualified technician is needed, however, to make

sure that the plugs are suitable for your ceiling. The ceiling must be strong enough to take the weight of the hood.

Disconnect the power supply at the home main switch during electrical connections.

Adjust extension of the hood support structure, as the final height of the hood depends on this, and remember that with

installation completed the hood must be at least 50 cm above the hob in case of electric cookers and 75 cm in case of

gas or mixed cookers.

Fix the two sections of the structure using 8 screws.

Place the ceiling hole diagram directly above the hob (the centre of the diagram must match the centre of the hob and

the edges must be parallel to the sides of the hob - the side of the diagram with the wording FRONT corresponds to the

control panel side). Prepare the electrical connection.

Drill as shown (6 holes for 6 wall plugs - 4 plugs for hooking), screw the 4 outer screws leaving a space of about 1 cm

between the screw head and the ceiling.

Fit an exhaust pipe inside the truss and connect it to the collar of the motor compartment (exhaust pipe and clamps are

not provided).

Hook the truss to the 4 screws (see step 4).

CAUTION! The side of the truss with connection box corresponds to the side of the control panel with hood assembled.

Tighten the 4 screws.

Insert and tighten another 2 screws in the remaining free holes for secure fixing.

Carry out the electrical connection to the mains power supply, only turn on the power supply with assembly completed.

10.

Hook the hood to the truss, check for perfect hooking - to hook the hood to the truss partially screw 4 screws (also see

step 12).

11.

Fixing the hood to the truss with two screws, will also facilitate centering the two parts.

12.

Tighten the 4 screws fixing the truss to the hood.

13.

For extractor operation (

13A

), connect the other end of the exhaust pipe to the home drain device.

For filter operation (

13F

), fit deflector

on the truss and fix it with 4 screws to the special bracket. Finally, connect the

exhaust pipe to the collar located on the deflector.

14.

Fit the nuts with fixing hooks supplied inside the top and bottom sections of the flues at the rectangular slots. A total of

14 nuts must be fitted.

15.

Join the two top sections of the flue to cover the truss so that one of the slots on the sections is situated on the same

side of the control panel and the other on the opposite side.

Screw the two sections with 8 screws and spring clips (4 each side - see the plan diagram for joining the two sections).

16.

Fix the top flue assembly to the truss, near the ceiling, with two screws (one each side).

17.

Carry out electrical connection of control panel and bulbs.

18.

Join the two bottom sections of the flue covering the truss using 6 screws and spring clips (3 each side - also see the plan

diagram for joining the two sections).

19.

Insert the bottom section of the flue in the special seat to completely cover the motor compartment and electrical

connection box, and fix the hood with two screws from the inside.

20.

Apply the 2 tabs (supplied) to cover the fixing points of the bottom flue

(CAUTION! THE BOTTOM FLUE TABS ARE THE NARROWER AND SHALLOWER ONES).

The wider and deeper tabs are those used for the top flue, and must be cut to size.

21.

Turn the mains power on again at the central electrical panel and check for correct hood operation.

INSTALLATION - ASSEMBLY INSTRUCTIONS

D F NL E

P I GR

DK FIN

61833021.fm Page 9 Monday, March 1, 2004 2:19 PM

5019 618

33021

HOO S00 - HOO S10 - HOO S40



Control panel.

Grease filter.

Halogen bulbs.

Steam deflector.

Telescopic flue.

To clean the grease filter

Wash the grease filter at least once a month.

Disconnect the electrical power supply.

Remove the grease filters -

Fig. 2

: pull the spring release

handle

(f)

downwards, then remove the filter.

After cleaning the grease filter refit in reverse order,

making sure the entire extraction surface is covered.

Carbon filter Fitting and Maintenance

Fitting the carbon filter:

Disconnect the electrical power supply.

Remove the grease filter

(f - Fig. 2)

Turn the side knobs 90° and then remove the filter

holder

(g - Fig. 3)

Fit the carbon filter

(h - Fig. 3)

in the filter holder

(i - Fig. 3)

Refit the filter holder and secure it to the hood with the

screw

(g - Fig. 3)

Refit the grease filter.

Carbon filter maintenance:

Unlike traditional carbon filters, this carbon filter can be

washed and reactivated.

With normal hood use, the filter should be cleaned once a

month. The best way to clean the filter is in a dishwasher at

the highest temperature possible, using a normal dishwasher

detergent. To avoid particles of food or dirt settling on the

filter during washing and giving rise to unpleasant smells, it is

advisable to wash the filter on its own. After washing, dry the

filter in the oven at 100° C for 10 minutes to reactivate it.

The filter will retain its odour-absorbing capacity for three

years, after which it must be replaced.

Replacing bulbs

Disconnect the electrical power supply.

Use a small screwdriver or any other suitable tool to

prise off the lamp cover

(Fig. 4)

Remove the burnt-out bulb.

Replace it with a PHILIPS STANDARD LINE bulb, code

425409 12 V 20 W 30° GU4 Ø 35 mm, or similar.

Close the lighting unit (snap-close).

CONTROL PANEL

Light ON/OFF switch.

ON/OFF and speed 1 selector switch

(small amount of steam and fumes).

B+C.

Speed 2 selector switch

(medium amount of steam and fumes).

B+D.

Speed 3 selector switch

(large amount of steam and fumes).

Fig. 1

Fig. 2

Fig. 3

Fig. 4

PRODUCT SHEET

D F NL E

P I GR

DK FIN

61833021.fm Page 10 Monday, March 1, 2004 2:19 PM

IKEA HOO S00 S Program Chart

Brand: IKEA

Model: HOO S00 S

Category: Cooker hoods

Type: Program Chart

This manual is also suitable for

Download PDF

report

IKEA HOO S00 S Program Chart

This manual is also suitable for

IKEA HOO S00 S Program Chart

Related papers

Other documents