Genie RB709U-NB User manual

Brand: Genie

Model: RB709U-NB

Type: User manual

RB709U-NB

Relay Output Universal Receiver

Owner’s Manual

The RB709U-NB digital receiver is a

wireless radio control designed for

use with automated gate openers and

garage door openers. The receiver

has two channels for receiving sig-

nals from two activation devices; i.e.

transmitters, multi-button transmitters,

wireless keypads, etc.

www.gtoaccess.com

Speciﬁcations

Compatible transmitter:

 •GTOgraynarrowbandtransmitters(318MHz)

Power input:

 •8-24Vac/dc,10mastandby,40maactivated(Red&Blackwires).

Outputs:2channelspulsedoutputs

 •2channelsdry-contactnormallyopenrelayoutputs.

 •Channel1:Blue(N/OContact)&Green(COM)wires.

 •Channel2:Yellow(N/OContact)&Brown(COM)wires.

 •Activatedfor.5secondswhenthecorrecttransmittercodeisreceived.

 •Relayswitchingmaximumrating:24Vac/dc@1A.

 •OperatingRange50to100feet(15.2to30.5m)

Indoor/Outdoorcompatible.

Mountreceiveratleast3feetfromACpowersource.

Mounting the Receiver Connect Receiver to Relay Inputs and Power

Consider the following when mounting the receiver:

•Standardreceivercablelengthis10feet(3.05m).

•Forexteriorapplicationsrunthecablethrough

PVCconduittoprotectitfromdamage.

•DONOTruncableinconduitcontainingacwiring.

•Thereceiverrangecanvaryfrom50to100

feet(15.2to30.5m)dependinguponweather,

topography,andexternalinterference.

FCC Regulation

This device complies with FCC rules Part 15. Operation is subject to the following conditions:

1. This device may not cause harmful interference.

2. This device must accept an interference that may cause undesired operation.

Transmitter distance may vary due to circumstances beyond our control. NOTE: The manufacturer

is not responsible for any radio or TV interference caused by unauthorized modiﬁcations to this

equipment. Such modiﬁcations could void the user’s authority to operate the equipment.

NOTE: Do not mount upside down.

Channel 1 (To COM)

Channel 1 (To N/O Contact)

Channel 2 (To COM)

Channel 2 (To N/O Contact)

2nd GATE OPERATOR or DOOR OPENER

1st GATE OPERATOR or DOOR OPENER

8 to 24 VOLT AC/DC

POWER SUPPLY

RED WIRE to POSITIVE

BLACK WIRE to NEGATIVE

RED

BLACK

GREEN

BLUE

BROWN

YELLOW

Designed to work with most brands of gate and

door openers.

Printed in China for GTO - Gates That Open, LLC

rev-090810

Programming the Receiver

Wiring Receiver to Common Gate and Door Openers

Wiring Receiver to GTO DC Operators

Wiring Receiver to GTO GP-SL100 & GP-SW100 Operators

Programmingtransmitter(s)orotheraccessdevicestoRB709U-NBreceiver:

• Pressandholdthetransmitter(device)buttontobelearned.

• Pressthe‘LEARNCH1’(or‘LEARNCH2’)buttonontheRB709U-NBreceiver

for1-2secondsoruntiltheredLEDturnson,thenreleasethebutton.

• Note:Whenthecorrectcodeisreceivedandthecorrespondingrelayoutput

isactivated,theredLEDwillturnon.

Channel 1 (GREEN WIRE to COM)

Channel 1 (BLUE WIRE to CYCLE)

BLACK

RED

Channel 2 (BROWN WIRE to COM)

Channel 2 (YELLOW WIRE to N/O Contact)

ALARM

ACC. POWER DUAL CABLE

+12Vdc

COM

DUAL LINK

LINK COM

RELAY OUTPUTS

LOCK N.C.

LOCK COM

LOCK N.O.

RUN 1

RUN 2

CLOSED 1

CLOSED 2

CYCLE

SAFETY

OPEN EDGE

RUN 2

OPEN

STOP

COM

SHADOW

LOOP

Check operation after programming:

• PressTransmitter(device)button,#1-REDLEDblinksoncetoconrm.

• PressTransmitter(device)button,#2-REDLEDblinkstwicetoconrm.

GTOGP-SL100andGP-SW100ContolBoard

TypicalGTODCpoweredgateoperators.

GTO2000XL,3000XL.4000XL,andMightyMule500

6 5 4 3 2 1

Genie Garage Door Opener

CHANNEL 1 (COM)

CHANNEL 1 (N/O)

Linear Garage Door Opener

PUSHBUTTON

COMMON

BEAM

ANTENNA

CHANNEL 1 (COM)

CHANNEL 1 (N/O)

Lift Master

Garage Door Opener

CHANNEL 1 (COM)

CHANNEL 1 (N/O)

Chamberlin

Garage Door Opener

CHANNEL 1 (COM)

CHANNEL 1 (N/O)

Lift Master SL580 Gate Opener

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

CHANNEL 1 (COM)

CHANNEL 1 (N/O)

CHANNEL 2 (N/O)

CHANNEL 1 (COM)

CHANNEL 2 (COM)

RED WIRE to POSITIVE POWER

BLACK WIRE to NEGATIVE POWER

BATTERY or

TRANSFORMER

SURGE PROTECTOR

(RB570 or R4215)

Channel 1 (GREEN WIRE to COM)

Channel 1 (BLUE WIRE to CYCLE/CLOSE)

BLACK

RED

Channel 2 (YELLOW WIRE to COM)

Channel 2 (BROWN WIRE to N/O Contact)

GRN BLK RED

RECEIVER

COM COM

CYCLE

SAFETY

EXIT

OPEN

SHADOW

LOOP

EDGE

OPEN

EDGE

J11

J12

8 to 24 VOLT AC/DC

POWER SUPPLY or BATTERY

RED WIRE to POSITIVE

BLACK WIRE to NEGATIVE

BATTERY or

TRANSFORMER

SURGE PROTECTOR

(RB570 or R4215)

GTO•3121HartseldRoad•Tallahassee,Florida32303•GTOSales1-800-543-4283•TechnicalSupport1-800-543-1236•www.gtoaccess.com

Connects to most garage

door openers the same

as a remote push button.

Genie RB709U-NB User manual

Genie RB709U-NB User manual

Genie RB709U-NB User manual

Other documents