On-Q 36477401 Operating instructions

On-Q
Brand
On-Q
Model
36477401
Category
Signal cables
Type
Operating instructions

This manual is also suitable for

INSTRUCTION / INSTALLATION SHEET
“F” to Twin-lead Apdapter
IS-0307 Rev. A
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2008 by On-Q/Legrand All Rights Reserved. Page 1 of 1
Fi
gu
r
e
1
Fi
gure
2
Fi
gure
3
I. Introduction
The On-Q/Legrand “F” To Twin Lead Adapter, PN
364774-01 (see Figure 1), provides a convenient
method of adapting stranded cable such as used with
Line Level audio or IR to a coaxial cable or jack. This
adapter can be utilized with wall plates that have “F” to
RCA inserts installed when needing to convert from
another connection that has screw terminals.
Applications that utilize line level outputs designed for
stranded wire such as active volume controls and the
stranded subwoofer output option of the On-Q Home
Entertainment Connection Center (HECC) can be
converted to a Coaxial run via this adapter.
II. Description
The On-Q “F” to Twin-lead Adapter consists of two 20 gauge cables attached to a male coaxial “F” connector.
III. Installation Examples
A. To drive a sub-woofer as part of a Home Theater installation utilizing the On-Q HECC (see Figure 2), run a
Cat 5 or shielded audio cable from the Home Entertainment Connection Center location to the location with
the wall plate containing an “F” to RCA Insert (sub-woofer connection).
1. Secure the cable leads to the Sub-woofer screw terminals.
2. Secure the other end of the cable to the “F” to Twin Lead Adapter.
3. Screw the “F” connector end of the “F” to Twin Lead Adapter to the rear of the “F” to RCA Insert.
4. The Sub-woofer’s two RCA inputs are connected to the RCA insert with a “Y” RCA cable.
B. To drive a sub-woofer from a volume control (typically in the same room), run a Cat 5 or pair of shielded
audio cables from the Volume Control location (see Figure 3) to the location with the wall plate containing
an “F” to RCA Insert (sub-woofer connection).
1. Secure the cables to the Volume Control press to insert terminals.
2. Secure the other end of the cables to the “F” to Twin Lead Adapters.
3. Screw the “F” connector end of the “F” to Twin Lead Adapter to the rear of the “F” to RCA Inserts.
4. The Sub-woofer’s two RCA inputs are connected to the RCA inserts with an RCA audio cable.
Shielded / stranded audio or
Cat 5 cable
lyriQ Volume Control
RCA to “F” Insert
(in wall plate)
Sub Woofer
“F” to Twin Lead
Adapter
RCA audio
cable
Shielded / stranded audio or
Cat 5 cable
lyriQ Volume Control
RCA to “F” Insert
(in wall plate)
Sub Woofer
“F” to Twin Lead
Adapter
RCA audio
cable
RCA to “F” Insert
(in wall plate)
“F” to Twin Lead
Adapter
Shielded / stranded audio or
Cat 5 cable
Sub woofer screw terminals
To Sub-woofer
RCA to “F” Insert
(in wall plate)
“F” to Twin Lead
Adapter
Shielded / stranded audio or
Cat 5 cable
Sub woofer screw terminals
To Sub-woofer
  • Page 1 1

On-Q 36477401 Operating instructions

On-Q
Brand
On-Q
Model
36477401
Category
Signal cables
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents