Wine Rack Shop Corner Liquor Bottle Rack Assembly Instructions

Hello! I am an AI chatbot trained to assist you with the Wine Rack Shop Corner Liquor Bottle Rack Assembly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Assembly Instructions for Corner Liquor Bottle Rack

Step 1. Align all rack uprights with ends marked “B” at the same end. This end of rack uprights is the bottom of

the rack and will sit on the baseboard unit.

Step 2. Slide both shelf sections together and attach shelf fastener piece using wood screws as shown. Repeat this

step for all three shelves.

Step 3. Insert bolt through pre-drilled rack upright hole and pre-drilled shelf hole. Hand-tighten nut on inside of

shelf. Do this for all five rack uprights. Repeat this step for all three shelves. Note: Shelves can be attached at

any hole position in rack uprights. Tighten all bolts with Allen wrench.

Step 4. Slide both rack top sections together and attach rack top fastener piece using wood screws as shown.

Step 5. Slide both baseboard sections together and attach baseboard fastener piece using wood screws as shown.

Step 6. Place assembled baseboard on level floor and set rack onto baseboard. Slide assembled rack top over rack uprights

and down onto rack uprights.

Step 6. Add bottles to your rack!