2. LEDPRO
  3. BY NORLUX TIGRUS VIPPBAR 36DOWNLIGHT, SVART

LEDPRO BY NORLUX TIGRUS VIPPBAR 36DOWNLIGHT, SVART Installation guide

  • Hello! I am an AI chatbot trained to assist you with the LEDPRO BY NORLUX TIGRUS VIPPBAR 36DOWNLIGHT, SVART Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
ledpro.no
Installasjonsmanual / Installation manual
• Ensure the power to the circuit being used is disconnected and will stay disconnected until the job is completed.
• Make sure the mounting surface is strong enough to carry the weight of the tting and the strength of the springs.
• Do not remove the cover or any part to modify wiring as this will not only compromise the IP rating but also warran terms.
Compromising with IP rating may lead to premature failure of the product.
Cut o the power supply before
start.
Cut out a hole in the ceiling at a
certain diameter given in the box
label.
Connect the line of 230V to the AC
input of the driver.
Connect the light to the driver via
the plug.
Put the driver onto the ceiling, then
pull the springs into vertical state.
Release the springs, it will lock the
lamp on the ceiling.
Turn on the power supply.
Insert the springs as well as the
lamp.
Ledpro by Norlux
Borgeskogen 32
3160 Stokke, Norway Page 1/2
ledpro.no
+47 33 30 10 80
[email protected]
Cutout: 76X83mm
ledpro.no
Safe Warnings, Precautions & Limitations:
Safe Warnings, Precautions & Limitations:
• The product must be installed, maintained and operated as per manufacturer’s instructions.
• Before starting installation of this product, make sure power supply is DISCONNECTED.
• Do not install the product if it appears damaged in anyway, check with manufacturer if in doubt.
• This product must be installed by a licensed electrician.
• Do not cover UNLESS manufacturer otherwise states the tting is suitable.
• Inspect the tting regularly. Any damage to the light tting, immediately cease use of the tting.
• Do not modify this tting in any matter as this will void warran.
• Check protection class, if class I, it must be earthed.
• Check tting application suitabili for indoor or outdoor use. Refer to IPXX or check with the manufacturer if in doubt.
• DISCONNECT FROM POWER SUPPLY BEFORE any maintenance or cleaning.
• Do not Megger between Line and Neutral.
Ledpro by Norlux
Borgeskogen 32
3160 Stokke, Norway Page 2/2
ledpro.no
+47 33 30 10 80
[email protected]
/