4. Assembling the saw bar and saw chain
e) Loosen the fastening knob (12) on the chain
wheel guard (11) and remove chain wheel
guard.
f) Place Saw Chain (9) on the guide bar (10) with
the guide groove (14) (P1)
g) Place the saw chain (9) around the chain wheel (15).
Heed the assembly direction.
h) Place the guide bar (10) around the guide groove(14))
i) Attach the chain wheel guard (11).
j) Tighten the fastening knob (12) only slightly
k) Hole (13) on the guide bar is the holder for chain
tensioning pin( 16).
l) Thread (17) is the holder for bar fastening knob(12)
m) Ensure that chain tensioning pin (16) is positioned in hole (13)
on the bar. The pin must be completely inserted into the hole.
n)
P1
P2
5. Tensioning the saw chain
a) Turn the guide bar fastening knob (12)
anti-clockwise slightly to loosen the the
guide bar.
b) Set the tension of saw chain using chain
tensioning ring (2). Turn this quick
tensioning device clockwise to increase
the tension and anticlockwise to loosen
the tension.
c) Tighten the fastening knob(12) to tighten the guide bar. Where
saw chain has been newly tensioned, re-adjust the chain tensio
n
after short period in operation.
Check the chain tension before each use of the Pole Saw
14
15
13
16
12
