AGI Wind Guard Operating instructions

I have reviewed the supplemental instructions for the Wind Guard mounting. This document details how to install the wind guard using specific hardware and provides instructions for connecting wind guard panels. I'm ready to answer your questions about this document.
What type of screws are used to fasten the wind guards to the support structure?

What hardware is used to connect the wind guard panels together?

SUPPLEMENTAL INSTRUCTIONS

0401681 1036792-1

NOTE Use this sheet in conjunction with the Wind

Guard Assembly Section of the appropriate Owner’s

and Operator’s Manual supplied with the equipment.

1. Using 1/4” x 3/4” (grade 5) serrated head hex head

capscrews and tinnerman nuts, fasten the wind

guards to the appropriate support structure. The

support structures are the inlet assembly, the

discharge assembly, the drive assembly and the

return roller supports.

2. Bolt the center flanges of each right hand wind

guard to its adjoining left hand wind guard, using

1/4” x 3/4” hex head capscrews with flat washers

and hex lock nuts.

WIND GUARD MOUNTING

INSTRUCTIONS

Publication No. 1036792