Solar Panel
USER MANUAL
Where should I install the Solar Panel?
∙ 1 x Solar Panel with weatherproof connector
∙ 1 x 360-degree Mounting Bracket
∙ Installation Screws & Wall Anchors
Materials: ABS + PC
Power: Max 2W
Output Voltage: 5V
Size: 9.9 in x 5.2 in x 0.8in (251 x 131 x 20mm)
Cable Length : 13.1 ft (4m)
You can mount the solar panel up to 13.1 ft/4 m (max cable length) away from
your
Blink camera. Install your solar panel at a location where it will receive a few hours
of direct sunlight daily. The solar panel can be mounted onto walls or roofs. If you
do not wish to drill holes we recommend you to buy our Solar Panel Gutter Mount
from Amazon (B07KHXD58X).
How do I mount the Solar Panel?
You can mount your device directly onto
wood using the included screws. If you are
mounting onto brick, concrete, or stucco,
mark the holes first using the bracket, drill a
hole for the anchors. You can then insert the
anchors and subsequently use the screws to
secure the mount.
How do I adjust the Solar Panel?
The 360-degrees rotatable mounting bracket
allows you to adjust the Solar Panel in the best
position to absorb sunlight.
How do I connect the Solar Panel to the Blink?
Attach the Wasserstein Solar Panel to your Blink
camera with the specially constructed weather-
proof charging cable. The charging cable is
designed to provide a continuous charge to
your camera even on days with minimal direct
sunlight. In order to plug this charger in the
camera, open the rubber cap located at the
bottom of your camera, and plug in the cable's
connector. Press firmly after you have plugged
in the cable to make sure it is sealed well.
Blink Outdoor/XT2/XT not included.
Wasserstein is a trademark of Dropcases Ltd.
Wasserstein is not affiliated with Immedia, Inc.
Blink Outdoor/XT2/XT is a trademark of Immedia, Inc.
For more information, please visit:
www.wasserstein-home.com
or contact us at:
Made in China
417.6 pt
590.4 pt
In the Box
Installation
Product Specifications
Sync Module 2 Operation
64 GB