SHYAM Networks SM410 Quick start guide

Brand: SHYAM Networks

Model: SM410

Category: Network switches

Type: Quick start guide

NETWORKS

www.shyamnetworks.com

Sparrow SM400

Series Camera

Quick Start Guide

For advanced settings and more detailed information, download the user

manual from www.shyamnetworks.com.

Package Contents

Camera 1

PoE Adapter 1

Mounting Kit 1

Quick Start Guide 1

NETWORKS

SM400

Available Models

1. Hardware Overview

INTERFACE DESCRIPTION

Microphone Built-in microphone present on the front panel, which records

sound. Used to capture audio from surroundings.

Lens Camera lens depending on the model.

LAN Port One Ethernet port providing connection through Cat5e cable.

MODEL DESCRIPTION

SM400 Indoor PoE camera

SM410 Outdoor PoE camera with metal casing (IP66)

Lens

Microphone

Sparrow Network Camera

Figure 1

Interface Description

Caution and Warnings

• Use the PoE adapter included with the product. Using a different PoE may damage

the product.

• The indoor model should be installed at a clean and dry place.

NETWORKS

SM400

Figure 2

2. Installing Sparrow

Mounting Sparrow

STEP 1 Loosenthethreecaptivescrewsinbubbleange.

STEP 2 Drill three holes into the wall. Then hammer the supplied plastic anchors into the holes.

STEP 3 Install the upper housing to the desired position with three tapping screws and

then connect the PoE cable.

STEP 4 Adjust the angle of the Len to aim at the shooting area.

STEP 5 Installthebubbleangetoupperhousingandsecurethemwiththecaptivescrews.

Location Hole Upper

Housing

Bubble

Flange

Cable Hole

NETWORKS

SM400

STEP 1 Placethecameraonaatsurfaceormountitontheceiling.

STEP 2 Connect power using one of the methods below:

• PoE Adapter: Insert one end of the Ethernet cable in the PC port and other

end into the PoE adapter. Connect another cable from the PoE port on the

adapter to the camera port.

• PoE Switch: Insert one end of the Ethernet cable into the PoE switch and other

end into the camera. Connect another cable from the PC into the PoE switch.

On powering-up; the LED near the lens glows green. If you get stuck refer to the

“Quick Troubleshooting” section.

Congratulations! The installation of the Sparrow SM400 series camera is complete.

Connecting Sparrow

Sparrow Camera

PoE Adapter

Switch

Computer

PoE Switch

Computer

Power Supply

Sparrow Camera

PoE Adapter

Figure 3

NETWORKS

SM400

3. Conﬁguring Sparrow

STEP 1 Power-up the camera.

STEP 2 CongurethePCconnectedtothecamerawiththeIPaddressrangebetween

192.168.1.1 to 192.168.1.254, except the camera IP address 192.168.1.168 and

set subnet mask to 255.255.255.0.

STEP 3 Type the http://192.168.1.168 URL in the Internet Explorer 6.0 or above version

to access the web interface.

STEP 4 Provide user name as admin and password as password to view the Live View page.

Please refer to “Sparrow SM400 Series Camera Conguration and User Guide” for more details.

Figure 4

NETWORKS

SM400

Accessing Sparrow by UPnP

WINDOWS VERSION PROCEDURE

ME or XP When enabled on your computer, Sparrow is automatically

detected and added to ‘My Network Places’.

Vista or Windows 7 When enabled on your computer, Sparrow is automatically

detected and added to ‘Network’.

The camera icon as it appears in Windows 7:

4. Adding Sparrow in Shyam Dicortex VMS

STEP 1 OpentheDicortexCongurationClientinterface.

STEP 2 Click the Settings tab.

STEP 3 Click the Add button to view the Add New Devices window.

After 5 to 10 seconds, the list of devices appears in the Add New Devices window.

Figure 5

Figure 6

NETWORKS

SM400

5. Quick Troubleshooting

PROBLEM PROBABLE REASON RESOLUTION

Unable to view the

Live View page on

the user interface.

Improper IP

conguration.

• Ensure that Ethernet cable is

inserted properly.

• Checkthatnetwork(IP)conguration

is done properly in the PC.

Video is unclear

or hazy.

Lens is dirty. Clean the lens with a soft cloth and

properly tighten it to the lens mount.

STEP 4 Select the desired model number and click the Add Selected Devices button.

The camera is added successfully to VMS.

Figure 7

NETWORKS

SM400

109.00027.00

SN/QS/SM400/09/11/R1.1

Warranty

This warranty is valid upto 12 months from the date of purchase.

Any manufacturing defect will be repaired by the company free of charge within the period of

warranty subject to the following conditions:

1. Thiswarrantycardmustbedulylledin,stamped&signedbythedealer.Thecardandthe

relevantcashmemomustbepreserved&producedalongwiththedefectiveunit.

2. Once the defective unit is repaired during the said warranty period, the warranty shall thereafter

continue only for the unexpired period to the original warranty.

3. This warranty is not valid in case of

• Damage resulting from accidents, mishandling, negligence, tampering, unauthorized repair,

failuretofollowinstructions,lightning,reandactofGod.

• Items not purchased from Authorized Dealers of the Company.

• Batteries (including rechargeable).

• Damage to the tamper proof seal.

• Adaptors (wherever applicable), where the Warranty is valid only up to 6 months from the date

of purchase of the product.

4. In case of a problem with your unit, please contact Customer Care. In the event that you are

advised to send and collect the unit from the Service Center of the Company – the same will be

done at your expense.

5. While Company or its Authorized Service Dealer will make every effort to carry out repairs under

this warranty as soon as possible, it is expressly made clear that the company shall not be held

liable for any direct or indirect loss to user due to delay in providing this service.

6. This warranty excludes every condition/warranty/liability not expressly set out therein.

7. Claims, if any to this warranty shall be subject to the courts having jurisdiction in Delhi, India.

Product ______________________________________________________________________

Model No. _______________________________ Serial No. ___________________________

Dealer’s Stamp & Signature Customer Care,

Shyam Networks (A Division of Vihaan Networks Ltd.)

21-B, Sec-18, Udyog Vihar, Gurgaon-122015

Haryana, India

Email: customer[email protected]

All India Helpline No. - +91 124 309 2000 Ext. 2009,

+91 9873573710

Manufactured by Vihaan Networks Ltd. Gurgaon, Haryana, India

SHYAM Networks SM410 Quick start guide

Brand: SHYAM Networks

Model: SM410

Category: Network switches

Type: Quick start guide

Download PDF

report

SHYAM Networks SM410 Quick start guide

SHYAM Networks SM410 Quick start guide

Other documents