VULCAN & WOLF QuickFry Filter User guide

Brand: VULCAN & WOLF

Model: QuickFry Filter

Type: User guide

www.vulcanequipment.com • Fryer Technical Support: 1-800-814-2028

MAKE SURE FRYER IS POWERED ON.

Always

filter the oil when hot at 300°F - 350°F

(150°C - 175°C).

• The display will indicate

DRN

.

• When the fry tank is empty,

press

FILTER

for 3-4 seconds.

• Allow the pump to filter the oil for a

couple of minutes before closing the

drain valve.

• Slowly open the drain valve

(to allow oil to flow into filter pan).

• Open the drain valve all the way.

• The fryer will automatically stop heating.

ENSURE THE FOLLOWING:

• The filter drawer is closed completely.

• The suction tube and receptacle block

are in the correct position.

Close the drain valve.

1. Follow filtering instructions 1-3.

Drain the fryer oil into the filter pan.

2. Attach the quick disconnect hose to the

discard male quick disconnect fitting.

Oil will immediately exit out

of the nozzle end of the hose any time the

hose is plugged in and the filter pump is

engaged.

3. To discard the oil, place the

nozzle end of the discard hose into

a container that is large enough to

retain the discarded shortening. Press

the discard switch behind the door

to the bottom “

ONLY USE HOSE TO

DISCARD

” position. This will allow all

of the oil to be pumped through the

hose only.

4. For flushing/rinsing the tank with

filtered oil to remove the particulates

that have accumulated, press the

discard switch behind the door to the

top “

USE HOSE TO RINSE & FILL

”

position. This will allow the oil to pass

through the hose and come in from

under the tank at the same time.

5. With the power switch still ON, press and

hold

FILTER

for at least 3 seconds. The

motor/pump will begin to operate.

6. Once the oil has been discarded completely

and the filter pan is empty, press

FILTER

to

turn o the motor/ pump.

7. Disconnect the discard hose. Be careful

to let the hose drain before putting away.

Close the drain valve and fill the fry tank

with new oil.

The hose connection will be

hot due to the temperature of the oil that

was discarded and can cause burns.

FLUSH / RINSE

& DISCARD OIL

 Hot oil and parts can cause burns. Use

care when operating, cleaning and servicing

the fryer. Do not leave unattended.

 Spilling hot frying compound can cause

severe burns. Do not move the fryer without

first draining all frying compound from tank.

IMPORTANT:

If power is mistakenly turned o during

the filtering operation, the corrective action

is as follows:

1. Close drain valve.

2. Turn power switch ON.

3. Immediately open drain valve.

4. Continue filtering operation.

Filter ONLY ONE FRY TANK AT A TIME to avoid

overflow and spillage.

NEVER RUN WATER OR BOIL OUT

SOLUTION THROUGH THE FILTER AND

MOTOR/PUMP. DOING SO WILL VOID

YOUR WARRANTY.

SLOWLY

OPEN

CLOSE FILL BETWEEN

MIN & MAX LINE

F49510 (08-01-23)

SUCTION

TUBE

RECEPTACLE

BLOCK

FILTER

DRAWER

ANALOG (A) CONTROL FILTERING GUIDE

QUICKFRY ™ FRYERS VHG MODELS

1

3

5

3

2

4

6Fill to between the MIN and MAX

lines. Do not fill past the MAX line.

• Press

FILTER

again to stop

the filter pump. The display

will begin to scroll:

VAT FULL? PRESS START.

• Press START.

• The fryer will then begin

heating the oil to the

desired temperature.

PRESS SECONDPRESS FIRST

7

1

VULCAN & WOLF QuickFry Filter User guide

Brand: VULCAN & WOLF

Model: QuickFry Filter

Type: User guide

Related papers

Other documents