ProCon_FVT-0103TXFC/ 0104TXFC
one world_one brand_one level_
100TX to 100FX-SC POE Converter
Related Products
FVT-0203TXFC
100TX to 100FX-SC MM
Converter w/POE Injector
FVT-0204TXFC
100TX to 100FX-SC SM
Converter w/POE Injector
Key Features Technical Specification
10/100Base-TX UTP to 100Base-FX fiber media
conversion
Complies with IEEE 802.3af POE standard
Over-currant protection and Under-currant
detection
Choice of SC connectors for multi- and single-
mode
DIP Switch to set configurations
Product Diagram
Standards Compliance
IEEE 802.3/ IEEE 802.3u
IEEE 802.3af Power Over Ethernet
Connector
10/100Base-TX: STP RJ-45
100Base-FX: MM SC, SM SC
Fiber Cable
50/125, 62.5/125 or 100/140m multi-mode
8.3/125, 8.7/125, 9/125 or 10/125m single-mode
Data Transfer Rate
100Mbps: 148,800 pps
10Mpbs: 14,880 pps
Flow control
IEEE802.3x for full-duplex
Backpressure flow control for half-duplex
POE Power Reception Supports
“Ethernet” via TP pin 1,2,3,6
“Mid Span”: via TP pin 4,5,7,8
LED Indicators
Power, PoE, TP Link/Act, 100, FX Link/Act, FDX/COL
Power Requirement
60mA@-48VDC from IEEE802.3af PSE or PoE injector
Temperature
Operating: 0°C ~50°C
Humidity
5%~90% (RH)
Dimension
26.2(H) x 70.3(W) x 94(D) mm
Certification
FCC, CE
Ordering Information
FVT-0103TXFC: 100TX to 100FX-SC Multi-Mode POE Converter
FVT-0104TXFC: 100TX to 100FX-SC Single-Mode POE Converter (20km)
LevelOne’s FVT-0103TXFC and FVT-0104TXFC are new Power-over-
Ethernet-converters that transfer data from 10/100BaseTX copper to
fiber interfaces. These POE Converters are designed to receive data
and power from POE networks and then to refer data out through
fiber connections thus eliminating extra power cables to extend the
usefulness of the network
LevelOne’s POE converter complies with IEEE802.3af standard. The
10/100 Base-TX port auto-senses 10 or 100Mbps connection speeds,
auto-negotiates half-/full-duplex modes, and auto-selects MDI-X
media type. It comes in two models: FVT-0103TXFC with Multi-mode
SC connector and FVT-0104TXFC with Single-mode SC connector.
These converters will give your POE network the ability to interface
with fiber connections over a distance of up to 20km.
With its compact design, our POE converters easily fit on any limited
space. No software is required. You can easily active this device by
simply connecting it to the network cable and it’s ready to go.
FVT-0103TXFC
FVT-0104TXFC
For more information, please contact your LevelOne representative, or visit www.level1.com
All technical specifications are subject to change without notice.
All mentioned brand names are registered trademarks and property of their owners
