Aeon co-in 125 User manual

1

TABLE OF CONTENTS

SECTION PAGE

FOREWORD 2 PREVIOUSLY INSPECTION 26-30

SAFETY RIDING GEAR 3 Check The Brake Light 26

GENERAL SPECIFICATION 4-5 Signal Light 26

PERIODICAL CHECK AND SERVICES

6 Spark Plug 26

OVERVIEW 7-8 Battery 27

INSTRUMENT AND OPERATION 9-19

Tire 28

Parts Location 9 Front and Rear Shock Absorbers 29

Instrument Panel 10-13

Check Front and Rear Light 29

Main Switch Operation 14 Check Horn 29

Handlebar Lock 15 Check License Plate 29

Electric Starter 16 Check Muffler 29

Head Light Switch 16 Idle Speed 29

Head Light Dimmer Switch 17 Fuse Replacement 30

Horn Button 17

Signal Light Switch 18 ENGINE START-UP AND CAUTION 31-33

Helmet Box 19 CORRECT RIDING POINT 34-36

PREVIOUSLY INSPECTION 20-25

Application of Brake 34

Engine Oil Check 20-22

Stop of the Vehicle 35

Change Gear Oil 22-23

Complete Stop 35

Air Cleaner 24 Parking 36

Front /Rear brake pad wear 25 TROUBLESHOOTING 37

2

FOREWORD

We take this opportunity to thank you for choosing our

co-in

110/125 motorcycle to serve you.

This owner’s manual is prepared for you the details as to operation and maintenance necessarily to

perform in safety. Therefore, we would like to recommend you to read this manual before you operate the

motorcycle.

It is our sincere wish that you enjoy operating the

co-in

110/125 motorcycle and getting fun from it.

Should you have any problem, please feel free to contact with our local dealer in your area.

NOTE:

This information and specification stated in the manual are for reference only subject to change

without notice. Thanks!

Product and specifications are subject to change without notice.

3

SAFETY

RIDING GEAR

Always wear protective clothing to reduce the chance of injury.

Always wear a helmet that meets or exceeds established safety standards.

Helmet

Long Sleeves

Gloves

Long Pants

Boots

4

GENERAL SPECIFICATION

Vehicle Type co-in 110 co-in 125

Length 1,620 mm 1,620 mm

Width 620 mm 620 mm

Height 1,040 mm 1,040 mm

Wheel Base 1,200mm 1,200mm

Net Weight 99 kg 102 kg

Engine Type 4-stroke, Single cylinder 4-stroke, Single cylinder

Cooled Air-cooled Air-cooled

Displacement 110cc 124.8cc

Bore × Stroke 52.4mm × 51mm 52.4mm × 57.9mm

Compression Ratio 10.3 : 1 10.3 : 1

Ignition System/

Idle speed EFI version: Digital transistorized with electronic advance

/ 1600 ±100 rpm

Spark plug NGK CR7E NGK

CR7E

Fuel tank capacity 6 Liters 6 Liters

Transmission System

C.V.T C.V.T

Starting system Electric motor Electric motor

5

GENERAL SPECIFICATION

Vehicle Type co-in 110 co-in 125

Front Telescopic fork Telescopic fork

Suspension Rear Single shock Single shock

Front 90/90-10 100/90-10

Tire Rear 90/90-10 100/90-10

Front Drum Disk

Brake System

Rear Drum Drum

Brake Oil --- DOT-4 Brake Fluid

Front Lamp 12V/35-35W HS1 12V/35-35W HS1

Position Lamp 12V/ LED (white) 12V/ LED (white)

Rear/Brake Lamp 12V/ LED (red) 12V/ LED (red)

Signal Lamp 12V/ LED (yellow) 12V/ LED (yellow)

Battery 12V-7Ah 12V-7Ah

Fuse 15A/15A 15A/15A

Engine Oil SAE 10W-40(0.9L) SAE 10W-40(0.9L)

Gear Oil SAE 80W-90(0.13L) SAE 80W-90(0.13L)

6

PERIODICAL CHECK AND SERVICES

FREQUENCY

ITEM

300

1000

2000

3000

4000

5000

6000

7000

8000

9000

10000

11000

12000

13000

14000

15000

Engine oil R

R R R R R

R R R R R R R R R

R

Oil filter C

C C

Gear oil R

R R R R R

Electronic fuel injection (system)*

D D

D D D D

Throttle Body * D M

D M

Ignition Coil * D D

D D D D

Valve, Idle Air Controller, IAC* D D

D D D D

Sensor, Engine Coolant, ECT* D D

D D D D

Sensor, Intake Air, IAT* D D

D D D D

Sensor, Topple Over* D D

D D D D

Battery * D D

D D D D

Electronic Control Unit* D

D D

Fuel Filter * I I I I

Oil Hose * I I I

Drive Belt * I I R I

Cam Chain * I I I I

Valve Gap * I I I I I

Air Clean C R

C R C R

Screw, Manifold, Intake * I

Spark Plug * I R

Nuts/Bolts * T T T T T T T T T T T T T T T T

Brake System * A A A A A A A A A A A A A A A A

Brake Hose * I I I I I

* SHOULD BE SERVICED BY YOUR DEALER

I: INSPECT AND ADJUST, LUBRICATE OR REPLACE IF NECESSARY

C: CLEAN R: REPLACE L: LUBRICATE A: ADJDJUST

T: Tight D: DIAGNOSIS M: MAINTENANCE

7

OVERVIEW OF URBAN

Upper/Left view

1. Font wheel

2. Front signal

3. Headlight

4. Gas Cap

5. Instrument panel

6. Side stand

7. Center stand

8. Helmet Box

9. Air filter element

10. Battery/Fuses

11. Exhaust

1 2 3 4 5 6 7 8 9 10 11

8

OVERVIEW OF URBAN

Font/Rear/Right view

1

4

5

6

7

1. Exhaust

2. Taillight

3. Passenger hand-hold

4. Seat

5. Font storage compartment

6. Rear signal

7. Front signal

8. Headlight

2

3

8

9

INSTRUMENT AND OPERATION

•

Parts location

1. Speedometer

2. Rear view mirror

3. Front brake lever

4. Throttle grip

5. Right switches

6. 12 Volt accessory outlet

(125c.c)

7. Main switch

8. Font storage compartment

9. Gas cap

10. Hook

11. Left switches

12. Rear brake lever

1

2

3

4

5

6

7

12

11

10

9

8

10

INSTRUMENT AND OPERATION

• Instrument Panel

Digitizer

1

2

3

4

5

6

7

8

9

10 11

12

13

14

15



Analog

1

2

3

4

5

6

7

11

Digitizer

Analog

INSTRUMENT AND OPERATION

• Instrument Panel:

1.

1. 1.

1. Back

BackBack

Back-

--

-light(Blue

light(Bluelight(Blue

light(Blue



Orange)

Orange)Orange)

Orange)

2.

2. 2.

2. High Beam Indicator

3.

3. 3.

3. Speedometer

4.

4. 4.

4. Oil service indicator

5.

5. 5.

5. Indicate the vehicle speed by KPH and MPH

6.

6. 6.

6. Fuel Level Indicator

7.

7. 7.

7. Turn Signal Indicator

8. Odometer

8. Odometer8. Odometer

8. Odometer

9. Time/Voltage

10. ADJ mode (

ADJ mode (ADJ mode (

ADJ mode (ODO

ODO ODO

ODO 



TRIP A

TRIP A TRIP A

TRIP A 



TRIP B

TRIP BTRIP B

TRIP B)

))

)

11. SEL mode (time

SEL mode (timeSEL mode (time

SEL mode (time



voltage)

voltage)voltage)

voltage)

12. Mileage Counter (ODO / TRIP)

(ODO / TRIP) (ODO / TRIP)

(ODO / TRIP)

13. Turn Signal Indicator

14. Battery Level Indicator

15. Engine warning Indicator

1. Engine warning

1. Engine warning 1. Engine warning

1. Engine warning Indicator

IndicatorIndicator

Indicator

2. Turn Signal Indicator

3. High Beam Indicator

4. Odometer

OdometerOdometer

Odometer

5. Speedometer

6. Oil service indicator

7. Fuel Level Indicator

12

INSTRUMENT AND OPERATION

• Instrument Panel

 Oil change indicator：

This indicator at the initial 300 km, then at 1000 km and

every 1000 km thereafter to indicate that the engine oil

should be changed. After changing the engine oil, reset

the oil change indicator.

Pushing ADJ button switches the display between the various

trip meter and odometer modes in the following order: ODO

TRIP A TRIP B; ODO mode pressing "SEL button" more

than 3 seconds oil change indicator will go off.

 Trip meter/Odometer

The display in the speedometer has three functions, ODO and TRIP A/ TRIP B.

The trip meter can register the trip distance.

The odometer registers the total distance that the scooter has been ridden.

By pressing "ADJ button" more than 3 seconds to select the odometer (mile or km).

1. Oil change indicator

2. ADJ button

3. ODO mode

4. SEL button

1

2

3

4

13

INSTRUMENT AND OPERATION

• Instrument Panel

 Engine trouble warning light：

This warning light comes on when an electrical circuit

monitoring the engine is defective.

When this occurs, have an AEON dealer check the self-diagnosis system.

 Fuel meter：

With the key in the “ON” position, the fuel meter indicates the

amount of fuel in the fuel tank.

The display segments of the fuel meter disappear towards

“E”(Empty) as the fuel level decreases.

When the fuel level reaches the bottom segment near “E”, the

fuel level warning indicator and the bottom segment will flash.

Refuel as soon as possible.

 Clock mode：

To set the clock, Press and hold the ADJ and SEL button for 3 seconds. The blinking digits can be

changed using the ADJ buttons. Press the ADJ button to move 0-24 in the 24-hour mode.

Press SEL button for 3 seconds to blinking digits can be changed using the ADJ buttons. Press the

ADJ button to move 0-59 minute. Press SEL button for 3 seconds to store the settings.

14

INSTRUMENT AND OPERATION

• Main switch operation

ON

All powers are connected and engine can be started. The key can’t

be removed.

OFF

All powers are cut off and engine stops. The key can be removed.

LOOK

The Steering shaft is locked and all powers are off. The key can be

removed to prevent pilferage.

FUEL

The fuel tank cap will jump up.

Upon release, key will return to .

OPEN

Turns the key clockwise to open seat up.

The key can't be removed.

Main switch

Check and ensure the handlebar

is

locked as the key at position

and take out the key to prevent

pilferage

.

15

INSTRUMENT AND OPERATION

• Handle Bar Lock

Turn the handlebar to full left end, push key in and turn anticlockwise from “ ” to “ ”.

The steering is locked and key can be removed.

Push key in and turn clockwise from “ ” to “ ” and handlebar be free.

1. After locking, turn the handle bar gently to ensure the handle bar is locked.

2. During riding, don’t turn the main switch to “ ” position.

16

INSTRUMENT AND OPERATION

•

Electric starter:

Press the start button and hold the R or L brake level to start the engine.

CAUTION:

1. The built-in side stand switch is part of the ignition circuit cut-off

system, which cuts the ignition in certain situations.

2. When press the start button, be sure to pull up the front or rear

brake level in order to connect the power supply

3. Don’t press the start button as the engine running condition.

• Head Light Switch:

1. At this position “

˙

”, the head, position and instrument light will

go out together.

2. At this position , position and instrument light will light

together.

3. At this position , head light will light.

NOTE:

The function of above is performed as engine is running.

17

INSTRUMENT AND OPERATION

• Head Light Dimmer Switch:

High Beam:

For farther light.

Low Beam:

For driving in the city or two vehicles meet.

• Horn Button:

Turns the main switch to “ON” and press

this switch to sound the horn.

Head Light Switch

Horn Button

Don’t press the horn switch in the “Silent Zone”.

18

INSTRUMENT AND OPERATION

• Signal Light Switch:

The vehicle will right turn while the right signal light is

flashing.

The vehicle will left turn while the right signal light is

flashing.

Signal Light

Switch

1. Turn off the signal light at once, after the vehicle makes a turn already.

2.

The signal swit

ch

will retur

n center position

, whe

n

press the signal

switch

.

19

INSTRUMENT AND OPERATION

• Helmet Box:

• The helmet box is under the seat. Turn the key to open the seat up.

•

Compartment not waterproof.

• To prevent damage, lock hood when operating motorcycle.

1. The load of helmet box shall be not

excess 10 kg.

2. Make sure the seat is locked before you

leave.

20

PREVIOUSLY INSPECTION:

For the sake of safety and prevent the damage of vehicle,

the previously inspection is absolutely required.

A. Engine Oil Check: (Refilling or change)

1. Place the vehicle by the main stand.

2. Start the engine, warm it up for several minutes, and then

turn it off.

3. Wait a few minutes until the oil settles, Take out the oil

gauge.

4. Clean the gauge and insert it into the hole.

5. Take the gauge out again and check the oil level. If the level

close to the lower limit, refill the engine oil to upper limit.

upper

lower

Dipstick

In order to maintain the excellent performance of engine, check the quantity of engine oil at each

500 km.

The temperature of engine and muffler is very high. Be

careful, while you check the engine oil or spark plug.

Page is loading ...

Aeon co-in 125 User manual

This manual is also suitable for

Aeon co-in 125 User manual

Other documents