Instructions for Converter Box Firmware Upgrade
Download and extract the firmware.
Then copy “flash.bin” and “usb_upgrade_all_flash.bin” to flash drive.
Insert Flash drive to converter box.
Press “MENU” on the remote
Select “SYSTEM”
Go to Software Update
Select “usb_upgrade_all_flash.bin”
Upgrading will show, after finish installing.
It is going to installation guide
Select “MENU” again
Go to “SYSTEM”
Select “Restore Factory Default”
Put in 000000 for password and hit OK
It will go to installation guide
It needs to reset the box to be able to work
